What transmission fluid does a 2001 Yukon take?

What transmission fluid does a 2001 Yukon take?

Valvoline Synthetic Transmission Fluid Dexron VI 1 Quart.

How many quarts does a GMC Yukon take?

The recommended oil for this engine size is 8 quarts of 0w-20 viscosity oil.

How much transmission fluid does a 2000 GMC Yukon take?

For Automatic Transmission: 4L60-E….AF6

Notes: This specification has been updated from Dexron II or III to Dexron VI per a Technical Service Bulletin from the manufacturer
Capacity: 4 speed 4L60-E Total Fill 11.2 quarts 5 quarts Initial Fill

How much oil does a 2002 GMC Yukon take?

6 quarts
Capacity: 6 quarts (with filter)After refill check oil level.

What kind of oil does a GMC Yukon Denali take?

Engine Oil

Viscosity: 10W-30 (Above -18) 5W-30 (All TEMPS) SAE 5W-30 is preferred.
Capacity: 6 quarts (with filter)After refill check oil level.
Torque: 18 ft/lbs (Oil Drain Plug)

What kind of fluid does a Chevy truck use?

Information about type and capacity fluid are for reference only. Reference book «Fluid type : automatic transmission Chevy Trucks and Vans». Full capacity l. Service fill l.

How to check transmission fluid capacity in a GM Truck?

Engine must be running, transmission in park, vehicle level, and the fluid hot. If the engine is not running you won’t get a correct reading. Engine must be running, transmission in park, vehicle level, and the fluid hot. If the engine is not running you won’t get a correct reading. Click to expand…

How much fluid does a 4 speed transmission hold?

Again, my transmission is the 4l60-e 4 speed automatic. Thx for the help and have a great day! 5 quarts. Put in a gallon first then slowly add the last quart to top it off, it may take a little more or a little less. Just keep checking it till its full.

Why is my Trans fluid so low in my GM Truck?

When the engines off the trans fluid runs back in the pan & reads higher on the stick than it does when it’s running, so you may have been sucking partial air & & causing your shifting problems due to lower pressure. Thanks again Stephan, Floyd & Matt. Using the correct procedure, I was 3 quarts low on fluid.

Posted In Q&A