Can you clean a governor pressure sensor?
Clean it with contact cleaner or similar electronics cleaner. I sprayed it over a Tupperware container, and kept spraying until there was little to no dirt or metal shavings left. Lay out you parts, and clean them thoroughly… Spray the filter and every hole on the main part of the unit, until it looks new.
What is a governor on a transmission?
Governor Pressure Electronic transmissions use the vehicle speed sensor signal for vehicle speed. Governor pressure causes a transmission to upshift, and throttle pressure causes it to downshift. Governor pressure works on one end of the valve, and a spring assisted by throttle pressure works on the other.
Can you clean a governor pressure solenoid?
A lot of the governor pressure solenoid failures are due to debris clogging the screen. If you are cheap you can pull it off and clean it real good with brake clean or anything just to blow the debris off the screen.
What is code P1762?
Q: A/T Governor Pressure Sensor codes P1762 P1763 My car has 124000 miles. The codes you’ve listed are Dodge specific OBD-II codes that indicate that the Governor pressure sensor is either faulty or relaying false information to the ECU.
How much does it cost to replace transmission pressure sensor?
Transmission Position Sensor Replacement Cost – RepairPal Estimate. Labor costs are estimated between $136 and $172 while parts are priced between $112 and $125. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
What replaced the governor in a transmission?
This valve has been replaced in electronic transmissions by the (VSS) Vehicle Speed Sensor.
How do I know if my transmission governor is bad?
Some of the most common signs of a bad transmission control module include:
- You have difficulty downshifting when you’re slowing down, coming to a stop, or manually trying to downshift.
- You have difficulty upshifting when you’re trying to accelerate or manually trying to upshift, which can cause a delay in acceleration.
Can a governor solenoid and pressure sensor solve a problem?
Governor Solenoid and Pressure Sensor. So I bought the parts, filter, new gasket and ATF4 fluid and went to a good local transmission shop in my town. It sounds to me like this is a common problem on the 46RE’s and these parts usually solve it.
Where is a governor pressure sensor and where is it located?
It is located in the valve body of the transmission. It governs the pressure for the up and down shifts of the transmission. It is number 30 in the picture. If you still need help just reply, if not clickACCEPTwhen we are done. Thanks, JB Ask Your Own Dodge Question Customerreply replied 11 years ago
What happens when the governor pressure goes up?
Now you take your foot off the break but don’t hit the gas. The car will slowly speed up and the governor pressure will go up. When the governor pressure is high enough it will overcome the spring and slide the spool valve over turning off first gear and turning on second gear.
How does governor pressure work in a transmission?
Shift Valves: Shift valves control hydraulic pressure flow to the reactionary devices (clutches and bands) that drive and hold members of the planetary gearset. Transmissions change gears by moving shift valves. Governor pressure works on one end of the valve, and a spring assisted by throttle pressure works on the other.