How much fluid do transmissions hold?
In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much.
Is the 46RH a good transmission?
The 46RH/RE transmissions are very good, from an engineering standpoint they are good. They can easily withstand up to the 600 ft-lbs torque they are rated for.
What is a 46RH transmission?
The 46RH transmission is a 4 speed automatic that comes out of the A518 family. It replaced the A727 and was preceded by the 46RE transmission starting on all 1996 models. The biggest improvement over the 727 was that it featured in overdrive.
How many quarts does a 46RE transmission take?
The Dodge 46re uses ATF+4 Transmission Fluid. It has a capacity of 4 quarts.
What’s the difference between a 46RE and a 46RH transmission?
They both use the same front half up to the bell housing, but the rear is different. The 46RH is longer overall and non computer controlled for shifting. The 46RE is the short one and is computer controlled shift points.
How much power can a 46RH handle?
I suspect a 46rh in good shape would hold up pretty well behind 300-350 hp, unless you’re really beating on it. If it needs to be rebuilt it can be upgraded with 47rh internal parts very easily and inexpensively.
When did the 46RH transmission get an update?
In 1993 transmission was updated. It received the torque converter and the solenoids valve. Also, it got the opportunity to block the clutch, which improved an off-road performance. To improve the dynamic performance automatic transmission 46RE/46RH had a special mode with three speeds.
What kind of fluid does a jeep 46RH use?
Original fluid type is MOPAR ATF+4, OEM number W0133-1969446-MPR. ATF+4 MOPAR Chrysler Jeep Dodge Automatic Transmission Fluid 1.3 Gallons 3 Pack. MOPAR AUTOMATIC TRANSMISSION FLUID, 5 LITER ATF+4 .
Is there a Repair Manual for a 46RH?
The legendary reliability is combined with the power and the ease of repair. Any special service work for this modification is not required. In the first version of A518 (46RH) was used a mechanical principle of lubrication. In 1993 transmission was updated. It received the torque converter and the solenoids valve.
Where is the solenoid located on a 46RH transmission?
The 46RH transmissions that were used from 1990-’95 have a three-pin electrical connector on the driver’s side of the transmission which controls two solenoids, the overdrive solenoid and the torque converter clutch solenoid. These two units are mounted inside the valve body on one common bracket.