How many quarts does a 700r transmission hold?
700r4 Transmission Specifications Chart
| Description | Spec |
|---|---|
| Fluid Capacity | 11 Quarts |
| Fluid Type | DEXRON VI |
| Max Torque | 350nm +/- |
| Image |
How much fluid does a TH700R4 hold?
I’m told the 700R4 holds about 11 quarts of fluid. My transmission builder says, “Put 6 quarts in the tranny, run it for about 10 seconds, then add 5 quarts and run it again.” Most passenger vehicles take from 12 to 16 quarts of transmission fluid, but the model of the vehicle dictates the type and how much.
What type of transmission fluid does a 700 r4 take?
DEXRON VI
This transmission can store about 11 quarts of transmission fluid and its recommended fluid is DEXRON VI. That aside, there was a K-case 700R4 transmission, and this was the 700R4 with the label K on its case.
What year is the best 700R4 transmission?
If you locate more than one of these transmissions, it is best to select the later model TH700R4. Design improvements were constantly added throughout the years it was offered. Generally, 1987 and up TH700R4s or 1990-’93 4L60 units are the most desirable.
How many quarts does it take to fill a transmission?
In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.
How much transmission fluid do I put in my torque converter?
When installing the converter onto the transmission, please pour approximately one quart of ATF (automatic transmission fluid) into the converter before installing into the transmission.
What year is the best 700r4 transmission?
How do you check transmission fluid on a 700r4?
Check the Fluid Level The first thing you’ll want to do is pull the dipstick out. As the transmission spins it slings fluid up the dipstick. This means that you need to wipe off this fluid and put the dipstick all the way back in. Once you do this you will have a nice clean and crisp reading.
How long does a 700R4 transmission last?
However, if a rebuilt unit is paid more attention and care in terms of small, regular maintenance jobs, this ‘like new’ unit could conceivably last as long as any new unit – around 150,000 to 200,000 miles on average.
How many quarts of fluid does a 700R4 hold?
700R4 holds 12 qts total and takes about 5 qts with a filter change BUT this is only a general guide, you must you the dipstick to determine the required amount. through all gears. Let ENG slow idle in PARK for at least 3 minutes. Check fluid level and add fluid as needed. Do not overfill.
What’s the difference between the 700R4 and the 4L60E?
The 700R4 and the 4L60E are the same. The only difference is you need a computer to control the 60e. The clutch packs, bands, and steels are all the same. If it’s going in a 3rd gen, you’ll probably want a 4L60E.
Are 700R4 transmissions good?
The 700R4, produced by General Motors/Hydramatic, is considered one of the best overdrive transmissions ever made. This transmission was introduced in 1982 as a replacement for the TH350 transmission, with the primary goal of improving fuel economy .
What is the weight for a 700R4 transmission?
The 700R4 case is a single piece constructed of cast aluminum. The transmission is 23.4 inches long and weighs 155 pounds. The transmission holds a total of approximately 11 quarts of transmission fluid.