How do you check the transmission fluid on a 2005 Honda Pilot?
at normal operating temperature.
- Park the vehicle on level ground. Shut off the engine. Remove the dipstick (yellow loop)
- from the transmission, and wipe it. with a clean cloth. 204. DIPSTICK.
- Insert the dipstick all the way into. the transmission.
- Remove the dipstick and check. the fluid level. It should be.
How do you check the transmission fluid on a Honda Pilot?
Check the automatic transmission fluid level (with the engine off and the car on level ground) with the dipstick in the right end of the transmission housing. Remove the dipstick and wipe it off. Insert the dipstick, remove it again, and read the fluid level. The fluid level should be between the upper and lower marks.
How do I add transmission fluid to my Honda Pilot?
Slowly pour in all four quarts of automatic transmission fluid through the funnel. Remove the funnel and the tubing from the dipstick tube. Reinsert the dipstick.
Where does the transmission fluid go in a Honda Pilot?
Locate the transmission fluid drain plug. This is on the lower driver side of the transmission. The drain plug has a big bolt head with a square hole in the center.
How to check the transmission fluid in a Honda Pilot?
If you don’t want to measure the amount of old fluid, I recommend only pouring in 3 quarts, start the engine, run the transmission through the gears, turn off the engine and check the transmission fluid level. Here’s the service manual procedure for checking the transmission fluid: 1. Park the vehicle on level ground. 2.
How much ATF can I take out of a Honda Pilot?
Allow the ATF to drain out for at least a few minutes or until the flow slows down to just an occasional drip. If you want to be certain of how many quarts of old fluid you removed from the transmission, make a gallon jugged measured out with quart markings on the side. We drained out about 3.5 U.S. quarts.
How to change the oil in a Honda Pilot?
Slide under the driver side of the engine bay and locate the drain bolt on the ATF oil pan. Insert the 3/8″ drive ratchet directly in to the square shaped opening in the drain bolt. Loosen the ATF drain bolt by turning it counterclockwise.
Where is the ATF filler bolt on a Honda Pilot?
Look behind the air intake hose and down to locate the ATF filler bolt. It is situated in between the brake fluid reservoir and the plastic engine cover. The letters “ATF” are stamped on the bolt head. Attach the 17mm socket to a long extension bar and a 3/8″ or a 1/2″ drive socket. Loosen the ATF filler bolt by turning it counterclockwise.