Where is the transmission dipstick on a Malibu?
Locate the automatic transmission fluid dipstick, labeled “ATF.” On the Malibu you will find the ATF on the driver’s side of the vehicle. Pull the dipstick out of the container and wipe it clean with a rag. Reinsert the dipstick completely then remove it again. Read the measurement on the dipstick.
How many quarts of transmission fluid do I need for a 2011 Chevy Malibu?
It’s in the owner’s manual, DEXRON VI, 7.0 quarts.
How to check transaxle fluid in Chevy Malibu?
Adding Transaxle Fluid: With the engine running, add fluid at the vent cap location in half liter (1 pint) increments until fluid drains through the fluid check hole. Allow the fluid to finish draining through the fluid check hole. 1. Install fluid level screw. Tighten 12 N.m (106 lb in) 2. Lower vehicle. Loading…
What should I do if my transmission dipstick says it still runs?
Place the funnel into the top of the dipstick and add a little bit at a time, depending on the reading of the dipstick. The engine still should be running when doing this on most vehicles. Once some fluid has been added, you’ll need to allow the fluid to drain down into the tube.
Where are The Dipsticks located in a car?
If you’re checking the dipstick properly and have to continuously add transmission fluid, there’s a leak in the system somewhere. Most transmissions are mounted to the back of the engine, so vehicles equipped with transmission dipsticks generally locate them on the lower side of the engine toward the back.
Where is the full level mark on a dipstick?
A full level mark and a low level mark will be stamped on the bottom 2 inches of the stick. The full level reading is the farthest away from the tip and the low level is the closest to the tip. Reinsert the dipstick (being careful not to get in the way of moving engine parts) carefully until it bottoms out in the dipstick tube.