How to troubleshoot the VSA system-Honda Civic?

If the indicator(s) of the system stays on, connect the HDS to the data link connector (DLC) (A) located under the driver’s side of the dashboard. 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the VSA modulator-control unit.

What are the trouble codes on a Honda?

Honda has issued a service bulletin 16-011 to address trouble codes P0335 and P0339 on the Honda vehicles listed below. Honda has determined that the P0335 — Crankshaft sensor no signal and P0339 — crankshaft sensor circuit intermittent interruption trouble codes are caused by corrosion in an electrical connector.

When do the indicators go off on a Honda Civic?

The indicators go off automatically when the system returns to normal. The indicators stay on until the ignition switch is turned OFF whether or not the system returns to normal. The indicators stay on until the vehicle is driven after the system returns to normal.

When does the VSA indicator switch go off?

Each indicator will go off after a problem goes away, but the timing which the VSA modulator-control unit turns off the indicators varies between DTCs. The indicators go off automatically when the system returns to normal. The indicators stay on until the ignition switch is turned OFF whether or not the system returns to normal.

Why is my power steering not working in my Honda Civic?

In many cases, the car’s power steering stopped working (EPS) without warning, startling the driver by how difficult it was to steer (like cars made before the 1980s). Some claimed they could not steer at all, while others said that turning was most difficult.

Why is my Honda Civic a / C not working?

Clogged condenser or radiator ﬁ ns A/C condenser or radiator fan not work- ing properly Clean. Check voltage and fan rpm. Check fan direction. Line to A/C condenser is excessively hot. Restricted ﬂ ow of refrigerant in system Restricted lines. Discharge pressure abnormally low Excessive bubbles in sight glass; A/C condenser is not hot.

Why is the EPs light not on on my Honda Civic?

However, if there IS damage to the steering rack and pinion, there usually is an odd sound and rough steering a driver can hear and feel. This usually occurs when turning. If the car’s CPU can’t be activated when the EPS light comes on, the DTC is not memorized.

How do you remove EPs code from Honda Civic?

Here is a way to try to remove the code that is stored in the system. You can turn the steering wheel 45 degrees to the left from a straight position. Then turn the ignition to ON. The EPS light should come on for 4 seconds and then go off. Immediately, when the EPS light comes off, return to the straight position.

Where is the VSA off and on switch?

VSA Off Switch This switch is under the left vent. Press it to turn the Vehicle Stability Assist system on and off. When VSA is off, the VSA Activation Indicator light comes on as a reminder. Pressing the switch again turns the system back on. Driving VSA SYSTEM INDICATOR Vehicle Stability Assist (VSA) System

Where is the VSA system indicator light located?

This switch is under the left vent. Press it to turn the Vehicle Stability Assist system on and off. When VSA is off, the VSA Activation Indicator light comes on as a reminder. Pressing the switch again turns the system back on. Driving VSA SYSTEM INDICATOR Vehicle Stability Assist (VSA) System

Where is the VSA light on a Honda Accord?

You’ll find it on the dash, to the left of the steering wheel. Press and hold this button until your hear a beep. The system will turn off, and the VSA Off light will turn on in the dash. Pressing and holding it (wait for the beep) will turn it back on.

What happens if your car does not have VSA?

Have your dealer inspect your car as soon as possible. Without VSA, your car will have normal braking and cornering ability, but it will not have VSA traction and stability enhancement. VSA Off Switch This switch is under the left vent. Press it to turn the Vehicle Stability Assist system on and off.

When does the VSA light come on on a Honda?

If one or more of the tires is not going around at the right speed the VSA system is going to know about it. On comes the light. Honda tells you about a dozen times in its manual not to put different sized tires and wheels on your vehicle than that which it came with. If you did, the VSA light is on to tell you you did so.

When do you turn on the VSA system?

Vehicle Stability Assist (VSA) System. VSA is turned on every time you start the engine, even if you turned it off the last time you drove the car. VSA and Tire Sizes. Driving with varying tire or wheel sizes may cause the VSA to malfunction.

How to fault reset Honda ABS and VSA?

Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).

Navigation