How do you turn off the service tire monitor light on a Chevy Tahoe?
First, try to fill up your tires with air and see if the TPMS light goes off. If not, drive around for 5-10 minutes. Turn your car off and then on again. This should automatically reset the TPMS light.
What does it mean when your car says Service Tire Monitor System?
Whenever your car says service tire monitor system, this means that more than likely you have a bad tire pressure monitor sensor (TPMS). This warning is just letting you know something is wrong with the TPMS. A TPMS or service tire monitor system, just lets you know when your tire pressure is too low or too high.
How do you reset the TPMS on a 2008 Chevy Tahoe?
Chevrolet Tahoe (2008 – 2012) TPMS Reset Procedure
- Apply parking brake.
- Press and hold unlock and lock buttons on the keyless entry transmitter until horn sounds, and then LF turn signal will become illuminated.
- Starting with LF tire, increase/decrease tire pressure until horn sounds.
Is it safe to drive with Service Tire Monitor System?
No, driving with the TPMS Light on is not safe. It means one of your tires is underinflated or overinflated. You can find the proper tire pressure for your car in your owner’s manual, or on a sticker located on the door, trunk, or fuel door.
How do I turn off my service tire monitor?
Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.
How much does it cost to repair a service tire monitor?
The service kit costs $5-$10 per wheel on most vehicles. A special TPMS tool and additional time are also needed to check and reset the sensor system. In the event pressure sensors need to be replaced, the cost ranges from $50-$250 each depending on vehicle type.
How do I fix my service tire monitor?
How do you reset the tire pressure sensor on a 2008 Chevy Avalanche?
Follow these instructions to get started:
- Turn the ignition key to the “ON” position without starting the engine.
- Turn the exterior lamp switch from AUTO to OFF 4 times within 3 seconds.
- Activate the TPMS sensor.
- Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire.
How much does it cost to repair a tire monitor?
The average cost for TPMS sensor replacement is between $207 and $257. Labor costs are estimated between $53 and $67 while parts are priced between $154 and $190. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
What is the service tire monitor light on a Chevy Silverado?
This article applies to the Chevrolet Silverado 1500 (1999-2006). The service tire monitor light is a warning bulb connected with the TPMS or Tire Pressure Monitor System, which notifies the driver of low or high air pressure in the tires.
Why did my service tire monitor go out?
“SERVICE TIRE MONITOR” warning came up, when I took it to the dealership they told me all 4 monitors were bad…I questioned how all 4 could go out at the same time and they told me that it was unusual but their computer is getting the same code for all 4. They suggested I start repairing one by one…just does not make sense to me.
How to replace tire sensor on Chevy Silverado?
However, once the the tire is removed, use the following instructions to replace the sensor. Mount a wrench on either side of the TPMS sensor and break it loose from the wheel. Remove the old sensor. Place the sensor behind the wheel. Mount the new sensor to the wheel. Figure 3. TPMS. If playback doesn’t begin shortly, try restarting your device.