What are the Torque specs for the connecting rods?
| Connecting Rod Bolt Specification | Steel Connecting Rods | |
|---|---|---|
| Part # | Dia. x U.H.Length | Torque |
| 90803 | 7/16″ x 1.940″ | 65 ft lbs |
| 90804 | 7/16″ x 2.320″ | 65 ft lbs |
| 90805 | 3/8″ x 1.920″ | 50 ft lbs |
What is the Torque on rod bearings?
Proper bolt torque: Torque rod bolts to 10 ft lbs on both sides, then torque to proper spec with one pull.
What are the Torque specs for the main bearing caps?
On the 3.0L engine, the main bearing cap bolts should be torqued in proper sequence to 14 ft. lbs. (20 Nm), then an additional 90 degrees and another 45 degrees after that. Also on the 3.0L engine, the connecting rod cap nuts should be torqued in proper sequence to 22 ft.
What are the correct Torque specs for the connecting rod bolts on a Briggs and Stratton engine?
What are the correct torque specs for the connecting rod bolts on a Briggs and Stratton engine? Torque spec on the rod bolts is 150 inch/pounds, and the top bolt must be torqued FIRST. The head bolts are 220 inch/pounds, and the torque should be laid on in several stages just to be safe.
How to determine the torque of a connecting rod?
STEP 1: Your Crower connecting rods came with a connecting rod specification tag. Check the tag to find the rod bolt part number used to fasten your connecting rods. Rod bolt length listed here is the measurement from under the head to the end. STEP 2: Use the chart below to determine the recommended lubricant, rod bolt stretch and torque amounts.
What are the specifications for Crower connecting rods?
Please read this entire page before starting to install your rods. STEP 1: Your Crower connecting rods came with a connecting rod specification tag. Check the tag to find the rod bolt part number used to fasten your connecting rods. Rod bolt length listed here is the measurement from under the head to the end.
Do you have to torque your rod bolts?
Torqueing your rod bolts without pre-determining the required torque to achieve the correct rod bolt stretch is not recommended. However if this is the only tightening method available to you, DO NOT EXCEED THE TORQUE AMOUNT INDICATED FOR YOUR BOLTS. NOTE: Your Crowerods are totally rebuildable.
Where do I find the rod bolt number on Crower connecting rods?
STEP 1: Your Crower connecting rods came with a connecting rod specification tag. Check the tag to find the rod bolt part number used to fasten your connecting rods. Rod bolt length listed here is the measurement from under the head to the end.