How do you tighten a parking brake lever?
Turn the lower nut clockwise down the thread, drawing the rod forward. Stop turning when the handbrake lever can be pulled up only three to five ‘clicks’. Adjust the other rod by the same amount. Grip the hexagon on the cable with pliers and adjust the adjuster nut, and tighten the locknut.
Why is my parking brake tight?
If you’re e-brake feels loose, it’s usually the wires that simply need to be re-adjusted. Most mechanical e-brakes are activated using thin steel cables that run from your e-brake handle, down to your brake mechanism. Over time, these cables develop slack and need to be re-adjusted.
What happens if parking brake is too tight?
If the parking brake fully engages in less than ΒΌ travel it could be too tight. Remember, too loose and the vehicle rolls; too tight, brakes drag and mpg is reduced. If the parking brake is fully engaged, with engine running place the transmission in a forward gear and try to move the vehicle. The brake should hold.
How do you tighten a parking brake cable?
This bolt tightens the cable leading to the rear brakes. Tighten the bolt by a few turns and then check the parking brake cable. Check the brake by pulling the lever up and feel for tightness. Keep tightening the bolt until the proper tightness is achieved.
How can I check the operation of the parking brake?
Step 2: Check the operation of the parking brake. To check the parking brake operation engage the parking brake and place the transmission in neutral. It should be tight at this point. Exit the vehicle and go to the front of the vehicle. Gently push back on the car, it should not move at all with the brake engaged.
What happens if you dont adjust your parking brake shoe?
The only part of this procedure that applies to disc-only systems is the adjustment of the cable system. Warning: Improperly adjusted parking brakes can lead to premature shoe failure, drum or rotor warping, and the distinct possibility of a fire at the rear wheels. The vehicle may also cease moving forward.
Where is the adjustment bolt on the parking brake?
Raise the boot up until you can view the adjustment bolt. Step 1: Adjusting the parking brake. The adjustment bolt will be located on the parking brake lever. This bolt tightens the cable leading to the rear brakes. Tighten the bolt by a few turns and then check the parking brake cable.