What are the 5 Steps to an oil change?
Steps for changing your oil
- Check the type and amount of oil needed.
- Get together your filter, wrenches, and other supplies.
- Prepare your vehicle.
- Locate the oil filter and drain plug.
- Drain the oil.
- Tighten the drain plug.
- Change the oil filter.
- Add the new oil.
What are the steps of a oil change?
Follow these steps to change your own oil:
- Step 1: Jack It Up, Open It Up.
- Step 2: Unplug It, Drain It.
- Step 3: Off With the Old Filter.
- Step 4: Drain Plug in, Filter On.
- Step 5: Fill It Back Up with Oil.
- Step 6: Check the Oil Level, Check for Leaks.
How do you change the oil in a Toyota Tacoma?
Since the engine compartment is essentially a sealed system, you’ll want to relieve the pressure inside the crankcase to allow the oil to drain faster and more efficiently. Before you loosen the drain plug completely, unscrew your oil cap and place it to the side. Once you’ve done that, go ahead and remove the drain plug bolt.
How often do you change the oil in a Toyota truck?
Your engine is pretty much the heart of your truck and as far as maintenance goes, there is nothing that requires more attention than your oil. Some sources recommend that you change your oil every 10k miles, but the majority of us (including Toyota) recommend that you change your oil every 5k for maximum performance and longevity.
What do you need to change transmission fluid in a Toyota Corolla?
The items needed to complete this procedure include a 14mm socket with a 3/8″ drive ratcheting wrench, a used oil catch container, a gallon jug marked in quarts, an automotive funnel a new crush washer & 4 U.S. quarts of genuine Toyota ATF Type T-IV.
What’s the best way to do an oil change?
Make sure the cap, drain plug and oil filter are all secure. Start the engine (outdoors or in a well-ventilated area), let it run a few minutes, turn off the engine, and then let it sit. Check the oil level again. Top-off if necessary and check one more time for any possible leaks. Clean up any spilled oil.