How hard is it to replace a drive belt?
Serpentine belt replacement is easy because today’s automatic drive belt tensioners eliminate the need to loosen bolts or pry components into position for retensioning. Just rotate the tensioner, remove the old belt and install a new one.
Can you put a drive belt on backwards?
it does not matter, as long as you always put it on the same direction. the arrows are there just to keep it consistent. if you put it on with the arrows facing back, always put that belt on that way. if you reverse it after the belt is broken in, it will tear the fibers apart and it will wear out very quickly.
How long does it take to replace drive belt?
For an experienced person, it will only take about 20-minutes, as the only concern will be to understand out how to loosen the tensioner bolt, and if the belt is the right one.
Does it matter which way you put a belt on?
Traditionally women wear their belts the opposite direction that men do. Men wear belts counter-clockwise, and women wear it clockwise, if you’re looking down at the belt.
How do you replace the belt on a Toyota Celica?
Replace the belt immediately whenever there is excessive cracking on the belt. Open the hood on the Toyota Celica and secure it in place. Locate the alternator on the front, driver side of the engine. Loosen the top pivot bolt on the top of the alternator bracket with the 1/2-inch drive ratchet and a socket.
What kind of alternator does a Toyota Celica have?
The Toyota Celica model cars that were built before 2000 came equipped with more than one engine accessory belt. The Toyota Celica models that were built after 2000 came equipped with a serpentine belt. The alternator belt on the Toyota Celica is driven by the crankshaft pulley.
How do you shut off a Toyota Celica?
Tighten the lock nut tight on the front of the adjustment bracket with the ratchet and socket. Tighten the top alternator bracket pivot bolt tight with the ratchet and socket. Crank the Toyota Celica and let the engine run for 30 seconds. Shut the engine off and recheck the tension of the belt. Close the hood.
How do you replace an alternator belt on a car?
Loosen the adjustment bolt counterclockwise until the belt is loose. Pull the belt out of the alternator pulley and the crankshaft pulley. Then, route the belt around the blades on the fan and out of the engine area. Route the replacement belt around the fan blades and into the crankshaft pulley and the alternator pulley.