How much does it cost to replace a Toyota door latch?
If you can’t open the door by pulling on either the inside or the outside door handle, you will have to replace the latch. Unfortunately, the latch assembly is a very expensive replacement product ($200), and Toyota does not sell replacement components for the assembly.
How to replace rear door handle, lock control rods?
Pull the door panel up and away from the door. Remove the white panel pin bracket from the door. From the rear portion of the door, peel back halfway the clear plastic vapor barrier. 7. Detach the Door Latch and Lock Control Rods
How to replace or repair the rear door handle, Door Latch?
Hardlymoving repairs and flips Toyota Camrys and has written extensively about these dependable cars. This do it yourself (DIY) article provides details on fixing or replacing the rear exterior door handle, door latch, or door lock actuator for the 4-door (1997-2001) Toyota Camry. The repair principles here will also work on other Toyota vehicles.
How does a Toyota rear door lock work?
The Toyota door lock actuator assembly encapsulates the motor and the gears it drivers in two black plastic covers. These covers are lightly glued together, and (as the last section of this article shows you) can be easily separated by striking the contact seams with a wide-tip screwdriver and hammer.
How do you repair rear latch on Toyota Sequoia?
Next I went to the bottom part of the door and removed the plastic shroud surrounding the lower door latch/solenoid and use a 10mm socket to remove the 10mm hex head screws. After I got the plastic panels off, I could see some electrical connectors going into a black box on the driver’s side of the rear hatch on a black stamped metal cover.
Is it possible to replace a Toyota door lock?
The actuator motor can be replaced, but is not available from dealers as a replacement part; they only have the complete door lock actuator assembly, for approximately $150. However, vendors on Amazon and eBay sell replacement motors for OEM (Original Equipment Manufacturer) providers of Toyota.
How do you replace a Camry door handle?
Once you get the cover off, you can replace the motor with a new one. The Camry-type replacement motor must have a brass collar attached to the end of the motor’s rod. A worm gear then slides over the collar. The worm gear, in turn, rotates the gears inside the actuator assembly. No specialized repair tools are required to replace these parts.