How do you remove a CV joint axle?
If auto theres no bolts on the trans it just slides out i believe. There are four bolts holding the axle in. Three nuts for the lower control arm come out so the arm swings down. One large axle bolt. That’s it. then you take a prybar and put itbetween the trans case and the axle shaft and use a hammer to hit hte bar.
How do you remove an axle from a VW?
Axle from the car needs no clamp to be removed. If auto theres no bolts on the trans it just slides out i believe. There are four bolts holding the axle in. Three nuts for the lower control arm come out so the arm swings down. One large axle bolt.
How do you get an axle out of a VW Rabbit?
One large axle bolt. That’s it. then you take a prybar and put itbetween the trans case and the axle shaft and use a hammer to hit hte bar. This will force the axle to come out of the trans. It’s actually the easiest axle to remove out of all VW’s. I have a 2008 VW Rabbit 2.5L.
Can a CV axle be replaced on a Passat?
Hello Chris, replacing cv axles on front wheel drive Volkswagon Passat, concerned about the condition of Transaxle axle carrier bearing, has very small amount of play in it. Can it be replaced easily?… read more
What to do if your CV axle nut is stuck?
You will need to use pliers to straighten the two bent ends of the cotter pin before you can remove it. If the pin is stuck, try spraying it the a penetrating lubricant from a hardware or automotive store. The lubricant should actually help with the axle nut as well. Remove the axle nut. Once the cotter pin is out, you can remove the axle nut.
Where is the outer tie rod on a CV axle?
Unbolt the outer tie rod from steering knuckle. The outer tie rod is literally a rod bolted to the steering knuckle, which is just behind the rotor. This piece will likely be bolted with another 17mm bolt. Like the axle nut, this bolt may be held in place with a cotter pin. Penetrating lubricant may help you more easily remove the pin and bolt.