Why does my maintenance required light stay on?

Why does my maintenance required light stay on?

Most often this just means your vehicle might be due for an oil change. The light will come on and remain on if the distance driven exceeds 5,000 miles after the maintenance data has been reset.

How do I get the maintenance required light to go off?

How do I reset the “Maint Reqd” light?

  1. Turn ignition switch to the ON position.
  2. Set the Odometer/Trip Display to TRIP A mode.
  3. Turn the ignition switch to the OFF position.
  4. Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.
  5. The Service Maintenance Reminder Light will.

How to turn off the maintenance required light on vehicles?

Turn your vehicle’s ignition to the “acc” setting while holding the button. Do not crank the vehicle. Hold the position for five seconds and turn the ignition key off. Release the button. The maintenance light will be reset and will illuminate again the next time service is due. Put the key in the ignition. Press and hold the odometer reset knob.

How to reset the Toyota maintenance required light?

Turn the Vehicle Off and Press the Trip Meter Reset Button Once you have turned the key back off, make sure that you press the trip meter reset button to reset the maintenance required light. Hold this button for a while. For some models, this is the button used to switch from the odometer reading to the other two trip meters. 3.

How long does it take maintenance light to go away?

I have all 3 turned off, stupid wrench won’t go away lol. Dealer did what they always do, reset to 8000KM, then I adjust that down to 5000KM and I go in around 6000KM. That gives me time to book an appointment 3 weeks in advance for a Saturday.

How to turn off the maintenance required light on Honda Civic?

How to Turn Off the Maintenance Required Light on a Honda Civic. Put the key in the ignition. Press and hold the odometer reset knob. This is the knob that sticks out on the bottom right of the instrument cluster. While holding this button, turn the key to the “On” position, but do not start the engine.