How do I fix a code po128?
What repairs can fix the P0128 code?
- Replacing the thermostat (most common repair)
- Replacing the coolant temperature sensor, or the wiring and connector associated with the sensor being damaged.
What causes a po128 code?
The most common cause for P0128 is the engine coolant thermostat is stuck open. When the thermostat does open, the hot coolant should start to flow and quickly warm up the radiator hose. If the radiator hose heats up slowly, the thermostat is stuck open or opening prematurely and needs to be replaced.
Can you just add coolant to your car?
You can use diluted coolant by itself, or a 50/50 mixture of concentrated coolant and distilled water. When the coolant rises to the cold fill line, replace the cap and tighten it until you feel it click.
How to reset the ” Check Engine ” light?
4 Ways to Reset the “Check Engine” Light Method Tools Required 1. Drive your car and let light go off b None 2. Turn the engine on and off three time None 3. Disconnect and reconnect the battery. Wrench 4. Use an OBD code reader. Wrench and OBD reader
What causes the Check Engine light to illuminate?
The Check Engine Light may illuminate with a fault code P1121 stored. It is commonly caused by a failed three way coolant control valve. Valve replacement is recommended if this occurs.
Can a check engine light get clogged up?
The EGR valve can get clogged up or fail entirely. If you’re even slightly mechanically inclined, you can remove the valve, clean it up, and reinstall it in a relatively short amount of time. If the valve needs to be replaced, expect to pay at least $125 for a brand-new, OEM-quality unit.
How much does a check engine light test cost?
The average cost for a Toyota Prius Check Engine Light Diagnosis & Testing is between $88 -$111. Learn More Engine light goes on intermittently…went to AutoZone and pulled a P1121 code (coolant control valve).