How do I turn off auto-lock on my Toyota?
Press and hold down lock “two” for about five seconds to disable auto-unlocking function when transmission is pushed back into “Park.” Listen for a response. The doors will all lock and then unlock when each process is complete.
How do you activate or deactivate the auto-lock feature?
How to Disable an Auto Door Lock
- Close all of the doors of your vehicle and make sure the perimeter alarm is disabled if you have one.
- Insert the key into the ignition switch and leave it in the “Off” position.
- Turn the key to “Run” and press the power door lock “Unlock” button three times.
What is a passive door unlock?
The Passive Entry system is an enhancement to the vehicle’s Remote Keyless Entry (RKE) system and a feature of Keyless Enter-N-Go — Passive Entry. This feature allows you to lock and unlock the vehicle’s door(s) without having to push the RKE Key Fob lock or unlock buttons.
How to change the lock sequence on a Toyota?
To change to the mode, push the lock switch until the light flashes to indicate that the desired mode is active. If the car battery becomes diconnected or dies then the car will reset to Mode 1. “Toyota 2005 Owner’s Manual;” Toyota Motor Corporation, 2004
What are the modes on the Toyota door lock?
Your choice is between four modes that are preprogrammed into the vehicle: Mode 1 – This mode connects the shift position with automatic door locking – but notably not unlocking. Mode 2 – This mode simply turns off the feature. Mode 3 – Similarly to Mode 1, this mode ties both locking and unlocking of doors with the shift position.
How do you activate or deactivate the auto lock feature?
Turn the ignition off. Press the Unlock button three more times. Turn the ignition back to on. The horn should beep once. This tells you that you’re now in programming mode. Press the Unlock button, then press Lock again. The horn will beep once to tell you that Auto Lock was deactivated.
How can I change the auto lock mode?
The number of flashes that come from the dome light will tell you the mode to which the automatic locking system is currently set. One flash tells you that you are in mode 1, while two, three, and four flashes signal that you are in modes 2-4, respectively. Push the switch to change to a different mode. It will flash to let you know the new mode.