Where are the timing marks on a Toyota RAV4?
Turn the camshafts with a wrench (using the hexagonal lobe) to align the timing marks of the camshaft timing gear with each timing mark located on the no. 1 And no. 2 Bearing caps as shown in the illustration. Using the crankshaft pulley bolt, turn the crankshaft to position the key on the crankshaft upward.
Is the Toyota 2AR-FE engine a good engine?
The 2AR-FE is a smooth, reliable, and efficient engine to safely get you from point A to B. It’s a great engine, but no engine is perfect. Though, we must admit the Toyota 2AR-FE is pretty close when it comes to reliability. In this article, we discuss a few of the most common Toyota 2AR-FE engine problems and overall reliability.
What kind of engine does a RAV4 sport have?
I have a 2010 RAV4 Sport, with the 4 cylinder 2ar-fe engine. 220K miles. Quick recap (see the above link if you want more detail) : I have the classic 2ar-fe rattle upon cold-start.
Why does my Toyota RAV4 rattle when I start the engine?
From what I’ve heard the rattle at start-up occurs when the engine is cold and all the oil has drained down to the pan. Starting the engine at this point means the overhead cam and all its surrounding parts are relatively dry until the oil pump gets some oil up top. That’s the way my V6 with VVT-i behaves.
How to set up timing chain marks on Toyota 2GR-FE?
The following thread will explain how we set up the Toyota 2GR-FE Timing Chain marks after re-installing the heads or performing engine work. Also we need to know which Bank is #1 and which Bank is #2. Here is a reference… Make sure that the engine is set to TDC… There are three timing chains on these 2GR engines.
How to install a chain on a Toyota RAV4?
Bolt length: Using an e10 “torx” socket, install the stud bolt for the v-ribbed belt tensioner Release the ratchet pawl, then fully push in the plunger and hook the hook to the pin so that the plunger is in the position shown in the illustration. Install a new gasket and the chain tensioner with the 2 nuts.
How to adjust oil pump on Toyota RAV4?
Align the adjusting hole of the oil pump drive shaft sprocket with the groove of the oil pump. Insert a 4 mm diameter bar into the adjusting hole of the oil pump drive shaft gear to lock the gear in position, and then tighten the nut.
How to change the camshaft position on a Toyota RAV4?
Remove the cylinder head cover. Turn the crankshaft pulley, and align its groove with the timing mark “0” on the timing chain cover. Check that the timing marks on the camshaft timing sprocket and camshaft timing gear are facing upward as shown in the illustration. If not, turn the crankshaft 1 revolution (360°), then align the marks as above.
Where are the timing marks on the cam located?
Align the marks on the timing belt with the marks on the camshaft pulley. Loosen the No. 1 idler pulley set bolt 1 / 2 turn. Turn the crankshaft pulley 2 complete revolutions TDC to TDC. ALWAYS turn the crankshaft CLOCKWISE. Check that the pulleys are still in alignment with the timing marks.
How to replace timing chain Toyota Rav4 or Camry?
PART 1 of 5. How to replace timing chain Toyota RAV4 or Camry VVT-i 2.0 or 2.4 – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.