Where is the fuse for the sliding door on a toyota Sienna?
engine compartment
Owners manual says Fuse 60 is for right side sliding door which is supposed to be located in the engine compartment. In this vehicle, per the diagram in the owners manual, the section that is supposed to contain Fuse 60 is contains no fuses and has a clear plastic cover over it.
How to reset the power door battery on a toyota Sienna?
Close the door, and wait 10 seconds. Open the door with the remote a third time. Once the third cycle completes, the power door battery is reset.
Where is the fuse box in a 2005 Toyota Sienna?
The fuse box is located under the instrument panel (on the left side), behind the lid.
Is there a power door switch on a Toyota Sienna?
I’m not familiar with the 2002 (1st Generation) Sienna, but in the 2004 (2nd Generation) Sienna, there is an “on/off” switch that controls the power to the power doors (if so equipped). This power switch is different and separate from the button (s) that open (s)/close (s) the door.
How much does a 2001 Sienna Le cost?
My 2001 Sienna LE right side power door quit working and was going to cost about $1200 for a new drive motor and ECU. I decided to remove the drive motor and cable to convert it to a manual door. It slides just as easy as the manual left side door now. It wasn’t too difficult to do.
Where are the fuse panels on a Toyota Sienna?
Here you will find fuse box diagrams of Toyota Sienna 2004, 2005, 2006, 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Where is the ECU on a Toyota Sienna?
You can only move the motor so much after you remove its bolts because the cable it still attached at both ends. The ECU is barely visible. If you follow the wiring harness bundles you can find it behind the sheet metal. It is held on by 3 plastic clips and a bolt. Remove the bolt, but leave it in place until you unplug the 4 plugs that go to it.