How do I set my Honda EVAP monitor?
Start the engine and idle for four minutes, then drive in stop-and-go traffic for five minutes using smooth accelerations and decelerations. Stop and idle for 4 minutes. The EVAP monitor should be complete.
How to check the drive cycle on a Honda?
The Honda Drive Cycle is included in recent owners manuals. You can either use an OBDII scanner or, if one is not available, check the MIL (check engine light) because Honda/Acura will indicate, on vehicle startup of the readiness monitors are set. When you turn the ignition to On-2 without starting the engine, the MIL will come on for 20 seconds.
What is the drive cycle for a 99 Honda?
Then let off the gas and let the car slow down and then stop. After than, you need to accelerate to 65, slow down to 50, and back to 65, then 50 a few times without hitting the brake.
Can a drive cycle work on a Honda Civic?
Keep in mind, my car is a 1999 Honda Civic so this drive cycle should definitely work if you drive a 1996-2000 Honda Civic. Hypothetically, this drive cycle should also work for Acuras between the same years. Older or newer Honda’s and Acura’s, I can’t guarantee this foolproof method will work but it’s worth a shot.
Is the Acura drive cycle foolproof or not?
Some disclaimers for this foolproof Honda/Acura drive cycle. Keep in mind, my car is a 1999 Honda Civic so this drive cycle should definitely work if you drive a 1996-2000 Honda Civic. Hypothetically, this drive cycle should also work for Acuras between the same years.
The Honda Drive Cycle is included in recent owners manuals. You can either use an OBDII scanner or, if one is not available, check the MIL (check engine light) because Honda/Acura will indicate, on vehicle startup of the readiness monitors are set. When you turn the ignition to On-2 without starting the engine, the MIL will come on for 20 seconds.
What’s the drive cycle for a Honda Acura?
Idle for 20 seconds again. Go to a highway and drive between 50-60mph for 20 minutes. You should be in D or 5th gear. Don’t utilize cruise control. At some point in the journey, coast for 90 seconds (take your foot off the accelerator). Conduct city driving for 10 minutes, and during this time, perform some coasting.
Then let off the gas and let the car slow down and then stop. After than, you need to accelerate to 65, slow down to 50, and back to 65, then 50 a few times without hitting the brake.
How does a drive cycle work on a car?
A drive cycle is one of the methods used by a vehicle’s powertrain control module (PCM) to determine whether an emissions system repair was performed successfully. It involves a special test drive that duplicates the scenario of a person starting the car and making a short freeway trip, as if driving to work.