Can I replace my clock spring?
If you remove the clock spring while performing a repair, it is often possible to reuse the clock spring. If the airbag has deployed, it is best to replace the clock spring with a new unit.
Can you bypass a clock spring?
There is no good way to bypass it, but you can use a “non-cruise” clockspring as a temp fix until you get the right one. Everything will work except the cruise control.
What causes a clock spring to break?
Clocksprings wear in time or become damaged during repairs to the steering column, or when removing a rack and pinion gear, gearbox, or coupling. If the steering wheel is allowed to spin freely, the clockspring’s connection may break, resulting in an open circuit and an illuminated airbag light.
How to set a new clock spring youcanic?
1 Start the engine and let it idle. 2 Turn the steering wheel all the way to the right. 3 Turn the steering wheel all the way to the left. 4 Repeat this procedure twice with the engine running. 5 Drive for at least 50 feet, and the steering angle sensor will reset.
How to reset the clock spring on a car?
How to reset a clock spring? 1 Start the engine and let it idle. 2 Turn the steering wheel all the way to the right. 3 Turn the steering wheel all the way to the left. 4 Repeat this procedure twice with the engine running. 5 Drive for at least 50 feet, and the steering angle sensor will reset.
What to do if your clock spring is broken?
Remove the clock spring while the steering wheel is in a neutral position and be sure not to turn the clock spring after you remove it. Reinstall the clock spring in the same neutral position.
Can a clock spring be removed from a steering wheel?
A general rule of thumb is if the steering wheel has a bolt it will lift off, and if it is using a nut it will need a puller. 4. Remove the Clock Spring: The clock spring sits over the center shaft of the steering column and is held in place by a set of small screws or plastic clips.