Where is the ignition switch on a Toyota 4Runner?
It might be a loose ignition switch on the back side of the tumbler. Autozone has the tumbler for $70-280 depending on the key. The Ignition switch (back side of the tumbler) is $64.99. That would be my first culprits.
How to replace a no start ignition switch?
GM Ignition switch replacement to fix a no start or intermittent start. Faulty ignition switch contacts can also cause the PassLock system to enable Click here to see step by step proceedures. http://www.thejunkmanadv.com/the-junk… Support the site, buy service manuals here : http://www.tkqlhce.com/click-7357719-… Loading…
What to do if your ignition key doesn’t stick?
several options: first remove the ignition switch (the electrical part of the ignition switch). You may have to lower steering column enough to get to screws on the back side. Then try your ignition key, if it still sticks, replace ignition tumbler.
Where can I get an aftermarket ignition switch?
You can sometimes get aftermarket ignition switches from your local auto parts store as well. Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module.
The 4Runner’s ignition switch is not what your key goes into. That is called the lock cylinder. The ignition switch typically sits directly behind the lock cylinder. It has three main functions. Power the Accessories- This should be what you get when you turn the key to the first position.
Where is the trouble light on a Toyota 4Runner?
With LED lights, polarity matters, the R-B wire is +12V and the W-B wire is ground. The two wires are run up to a 12V outlet screwed to the side of the bed rail. The LED trouble light plugs into that outlet and can then be turned on (image above-right) or off from either the switch at the deck light or from the deck light switch on the dash.
How do you re-power a Toyota 4Runner?
First step is to re-power it off the battery. Pull the lower dash off, disconnect the deck light plug and find the dark green wire (upper left of the connector) – that supplies power to the whole circuit. I cut it, spliced in a male and female spade connector and then tapped into my CB radio power feed.
Where are the fuel pumps on a Toyota 4Runner?
Here are a few handy tips and tricks for working on the high pressure EFI fuel pumps on Toyota 22RE/22RET and V6 (3VZE) trucks. In the 1st generation Toyota 4Runner, there is a handy access hatch under the rear seat cushions.