How do you change the fuel line on a Honda Accord?
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line. Rotate the wrench counterclockwise to loosen the bolt, and then remove the fuel line by hand.
What to do if you spill gas on your Honda Accord?
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line.
Where is the fuel filter located on a Honda Accord?
The fuel filter location is different on certain model years. 1990-1994: Accord fuel filters are located on the passenger’s side firewall. 1995-2002: Accord fuel filters are located on the rear of the engine, near the brake master cylinder.
Can a Honda Accord fuel pump relay be replaced?
Honda Accord 2.4L / 3.5L 2009, Fuel Pump Relay by WVE®. Replace your worn-out or faulty component with this quality replacement from WVE. This product is designed and tested to ensure the ultimate in durability and functionality. Made…
What kind of fuel tank does a 2009 Honda Accord have?
Honda Accord 2.4L / 3.5L 2009, Replacement Non-Locking Fuel Tank Cap by Gates®. Expertly designed with top-of-the-line technology to outdo the competition, this one-of-a-kind product will surpass your highest expectations. It was made… Honda Accord 2.4L 2009, Throttle Body Mounting Gasket by Mahle®.
Place the fluid catch pan under this area to catch any spilled gas. Once the nut is removed, pull the lower fuel line off and set it aside. Then, use the 17 mm flare nut wrench to loosen the Banjo bolt on upper fuel line.
What kind of fuel injection does a Honda Accord use?
Honda Accord 2009, Fuel Injection Throttle Body by Spectra Premium®. Spectra Premium’s 100% new Electronic Throttle Bodies are built from the ground up using precise manufacturing and quality control to ensure smooth driving and long…
Do you need to replace the fuel filter on a Honda Accord?
This article applies to the Honda Accord (1990-2002). For Honda owners who don’t perform regular maintenance, one of the items that eventually needs to be replaced is the fuel filter. But it’s not as bad as it sounds. If you are overdue for this task, you may notice that under tougher and steeper road conditions your Accord might feel sluggish.
How do you remove fuel lines from a fuel filter?
Remove the fuel lines from the filter. With the clips removed, slide the fuel lines away from the filter to pop them off of the nozzles on either end. Make sure to tip the fuel lines toward the bowl or bucket in place as you remove them to catch any spilled gasoline.
How do you change the fuel line in a Honda Accord?
Screw the bottom fuel line into the bottom of the fuel filter. Tighten the fuel line nut with the 14mm open end wrench. Screw the top banjo bolt into the top of the fuel filter. Tighten the banjo bolt with the 17mm open end wrench. Slide the catch pan out from under the Accord.
Where is the fuel filter on a 1991 Honda Accord?
A dirty fuel filter can prevent your 1991 Honda Accord from running smoothly or even from starting. It is not designed to last for the life of the car, and is not difficult to replace. It is located on the passenger side of the engine compartment near the back.
How do you replace a fuel filter clamp?
Unclip the alignment hole holding the top of the fuel filter in place, and then remove the fuel filter from the clamp. Dispose of the old filter and place the new fuel filter in the clamp. Then, insert the fuel filter clamp to its original location and secure it with the two 10 mm bolts. Figure 6. Remove and replace the fuel filter from the clamp.