What is a sensor heater circuit Bank?
This code indicates that the Engine Control Module (ECM) has tested the oxygen sensor heater circuit and has found a problem with sensor 1 in bank 1. Bank 1 refers to the side of the engine that has the #1 cylinder. The ECM also monitors how long it takes the sensor to warm up so it can send an adequate signal.
Can you drive a car with a bad oxygen sensor?
Can You Drive With A Bad Oxygen Sensor? Yes, you can drive with a bad oxygen sensor if you can still start your engine and feel little difficulty driving. But don’t leave it alone for over a couple of days, as it might cause safety problems and lead to the malfunction of other parts of your vehicle.
What causes the OBD-II trouble code p0135?
P0135 is the OBD-II generic code indicating the engine control module (ECM) has tested the O2 sensor heater circuit and has detected a problem with the bank 1 sensor 1 O2 sensor heater circuit. What causes the P0135 code?
What does the p stand for in OBD-2?
In this case, the letter ‘P’ indicates a generic powertrain code. If the engine control module detects that the oxygen sensor heater circuit is open, short, or draws too much current based on coolant temperature, the onboard computer will output OBD-II diagnostic trouble code P0135.
How to check for O2 sensor trouble code?
Common mistakes when diagnosing the P0135 code 1 Not checking the O2 wire harness for water entry into the harness cover 2 Not checking the O2 sensor for oil or other contaminants 3 Not scanning the new O2 sensor to make sure the heater circuit works 4 Replacing parts before conducting thorough pinpoint tests and visual checks
How much does it cost to repair a p0135 Pontiac?
The cost to diagnose the P0135 PONTIAC code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.