Why does blower only work on high?
Most car manufacturers use a series of resistors to make the heater blower motor run at different speeds. And when one or more of these resistors burn out, you’re usually left with only one heater blower motor speed—high. The resistor module is easy and inexpensive to replace.
Why is my blower motor not working on high?
In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. Start by checking the blower fuse and HVAC controller fuse.
Why does my AC blower motor not work?
The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all. This may also cause the blower motor to work intermittently.
Why is my blower not working in Hi ( 5 )?
The usual failure of the resistor pack is if it works in HI (5) but not in any other mode or just a few modes. When you switch to high,the blower motor relay coil circuit is grounded and voltage is now applied directly through the relay to the blower motor; bypassing the resistors. So, I would look to see if the relay is ok.
Why does my heater not work on high speed?
Heater blower motor will not work on high speed? I have replaced the black bosch relay behind the glovebox, the blower resistor and the blower motor and still cannot get the blower to work on high. I remember in older model years of gmc’s and chevys that their was a high speed blower relay that caused this issue.
Why is the resistor not working on my blower?
Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.