Who is responsible for cable line from pole to house?
A homeowner’s responsibility for the incoming electric service usually starts where the utility companies wires are attached to the home. In the case where your meter is on a pole away from the building, your responsibility will usually start where the service wires are attached at the top of the pole.
What do you call a bunch of wires?
More often than not, the terms wire and cable are used to describe the same thing, but they are actually quite different. Wire is a single electrical conductor, whereas a cable is a group of wires swathed in sheathing.
How do you trace electrical wires without electricity?
To find wires without any power one of the handiest tools is an electronic stud finder. Most stud finders are equipped to handle finding wooden studs in the wall, but some can also be used to find wires as well. To find out if a wire is live, you’ll also need a voltage detector.
What happens if I drill into a wire?
Partial severing of a conductor would not disable the circuit, but it could cause a hot spot in cases of high, sustained current flow. Wiring is not run level with the outlet boxes. It’s typically 8-12″ above them, with drops into the boxes from above. The cables might also run along the studs from above or below.
What are the three wires from pole to house?
The electric power line enters our house through three wires- namely the live wire, the neutral wire and the earth wire.
How do I remove cable wires from my house?
Cable companies tend to run wires straight inside to televisions inside the home. They then caulk the holes to seal them from the outside. If this is the case, simply peel away at the caulk with a knife until the cable breaks free. Pull or push the remainder of the cable through the hole.
Does solid or stranded wire carry more current?
Because of the given thickness of stranded wire, i.e., it’s thinner, there are more air gaps and a greater surface area in the individual strands of wire. Therefore, it carries less current than similar solid wires can.
Why does my light switch have 3 wires?
The 2 wire source feeds to an adjacent switch for a different light which then feeds this switch with 2 wires. The switch in question is a single pole. From it, there is 3 wire cable that leads to a light which then connects to other lights controlled by their own switches.
How are wires bunched together in a strand?
Several single wires or bundles are bunched together. Those single wires do not hold a fixed position inside the strand. Their position relative to one another undergoes a permanent change along the entire length of the bunch.
What’s the sub trope of the wrong wire?
The Wire Dilemma has a minor Sub-Trope in the Wrong Wire. See also Bomb Disposal, Operation Game of Doom, Cut the Fuse, and Relocating the Explosion . An ad circa late 90s featured a scene like this, with the guy advised to cut the cyan-colored wire.
What’s the proper amount of exposed wire for a wire connection?
Make sure there is the proper amount of exposed wire showing (for most connectors, this means about 3/4 inch), then join the wires together with a wire nut or other approved connector (there are now push-in connectors that some pros like to use).
Where is the red and blue wire in Haruhi-chan?
In Haruhi-chan, Yuki had left the house, and to entertain Ryoko and Kimidori (a green balloon dog) she had left a gift. They unwrap it, and it’s a large box with a timer…and a small compartment with a red wire and blue wire opens up, along with a pair of scissors. They chuck it out the window.