Where is the OBD plug on a Toyota Prius 2?
OBD connector location for Toyota Prius 2 (2003 – 2009) You will find below several pictures which will help you find your OBD connector in your car. The connector is on the left under the steering wheel. Go to the OBD2. scanner for TOYOTA. Near the brake pedal. OBD Connector. Those pictures were sent by Thierry.
Why do I get No OBD code on my car?
Blown Fuse If you’ve plugged into your car’s diagnostic port and aren’t reading anything, you might think that your OBD-II brain has been fried, but don’t declare it dead yet. The most common reason for getting no OBD code is simply a blown fuse.
Why does my Toyota engine have a code p0401?
When code P0401 is triggered, it’s because the DPFE sensor found too little recirculation. This code indicates that too much exhaust gas recirculation (EGR) is occurring — the result is an overly-rich mix of oxygen in the air/fuel ratio and higher engine temps.
Are there any trouble codes for Toyota cars?
Has been updated to the Master Sticky (or will be very shortly). So here goes – And please note: The P1xxx codes are all Toyota Specific, and the P0xxx are General and will relate to all cars. Not open for further replies. Did you find the recommended reading relevant to this discussion?
Which is the best OBD reader for a Prius?
The best OBD2 reader for a Prius is the MiniVCI (Requires MS Windows). Another option that is reasonable is Torque Pro ($5 plus an OBD2 interface and requires Android). Most others have limited functionality on a Toyota. Georgina Rudkus and valde3 like this.
Is there a diagnostic scan tool for the Prius?
Discussion in ‘ Gen 2 Prius Care, Maintenance and Troubleshooting ‘ started by New Revelation, Sep 10, 2006 . For the Prius, would it be possible to obtain the scan tool somehow so that we would be able to pull codes from the car?
What does version 1.4.1 do on a 2006 Prius?
On my 2006 Prius. Version 1.4.1 instantly disables the car and reads a bunch of “U” codes. U codes are can bus communication errors. It is the Mini VCI causing the errors. Version 2.0.4 will connect and read codes.