How to repair rear wheel brake on Toyota Corolla?
Apply chalk to the inside surface of the drum, then grind drum on the brake shoe lining to fit. If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly. 12. Remove rh, front or upper rear wheel brake cylinder assy
How do you overhaul a Toyota Corolla RH side?
: overhaul the rh side by the same procedures with lh side. 1. Remove rear wheel 2. Drain brake fluid : wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove the brake drum.
How to adjust the rear drum brake on a Toyota?
Check the e-brake to see if it adjusted. Usually it takes a few times. If the reverse trick alone isn’t helping, then you actually have to variably engage the e-brake while in reverse (as stated by fj62 above) to make the rear wheels rock a bit. This will free up the adjustment mechanism that tends to bind up.
How do you install a rear brake shoe?
Install rear brake shoe Using a needle–nose pliers, connect the parking brake cable no.3 To the parking brake shoe lever. Using sst, install the rear brake shoe, pin, shoe hold– down spring and cup.
How to replace rear wheel bearing hub assembly?
Screw the two M8×1.25 bolts into the holes in the drum brake to push it away from the hub. It may be rusted to the hub so prepare for some cracking sounds. Remove the drum once it is free 8. Remove the four 12mm bolts on the back of the hub.
How do you remove a rear brake shoe?
Using sst, remove the cup, shoe hold–down spring and pin. Using a needle–nose pliers, disconnect the parking brake cable no.3 And remove the rear brake shoe. remove the upper side return spring from the rear brake shoe.