How do I reset my Range Rover sport gearbox?

How do I reset my Range Rover sport gearbox?

Re-Setting Automatic Gearbox

1. Press Start button but don’t turn on the engine.
2. Press the Accelerator down to the floor for about 15 seconds.
3. Hit the start button again to turn off the power.
4. Remove foot from Accelerator.
5. Waity for 2 Mins.
6. Start the engine and Drive.

How do you reset a Land Rover Discovery?

How do I perform a reset, when my screen is blank?

1. To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
2. The device will power down and then automatically reboot.
3. Device will now power on, perform and charge as expected.

Where is the XYZ switch on Discovery?

It is on the left side of the transmission. As the shifter is moved, a cable moves the switch and various contacts make or break, telling the tranny computer what the driver has selected.

How do you reset a Range Rover window?

2018 Range Rover Velar

1. Close the window fully.
2. Release the switch, then lift it to the close position. Hold for 2 seconds.
3. Release the switch.
4. Repeat the lift and release procedure twice more.
5. Test the window for correct manual and automatic switch operation. See ELECTRIC WINDOWS.
6. Repeat the procedure on each window.

How do you reset a Land Rover Discovery 3?

In brief, to start the hard reset process, open the hood but close all doors and let your 3 go to sleep – no radio display etc and no key in the ignition. This will take a couple of minutes and do not open any doors until the reset is completed.

How do you reset the service light on a Land Rover Discovery sport?

2014-2019 LAND ROVER DISCOVERY SPORT SERVICE LIGHT RESET Open the driver’s door. Hold the accelerator and brake pedals all the way down until you see SERVICE RESETTING in the dash. Turn off your car and start the engine to see if the warning went away.

How do I get my Land Rover out of park?

Turn the locking mechanism 90° anti-clockwise. Press the brake pedal. Use the strap to pull the transmission park release mechanism upwards, until it latches in the vertical position.

How do you drive a Land Rover Discovery 2?

Shifting into 4WD low in a Land Rover Discovery 2 is a process that requires some muscle and conviction. Normal Driving is done in 4WD high with the lever pulled towards the rear and passenger side of the vehicle. Shifting to 4WD low requires a firm push towards the engine of the car.

Can a Land Rover Discovery go up steep inclines?

You can go up really steep inclines more easily but you can’t go very fast. Land Rover Discovery 2 vehicles between the years of 1999 – 2004 came equipped with an electronically controlled manual mode to be used with a 4WD low transfer case setting.

What to do when Your Land Rover wont shift out of Park?

Fuse F1 in the fascia fuse box. (Discovery, if the fuse blows, check the terminals on the back window grids making sure they are not touching each other causing a short. They get bent easily). Inspect the brake light switch on the brake pedal (the brake light switch has four wires on it and the cruise switch has two wires and a vacuum line on it).

Can a 4WD Land Rover use a diff lock?

Diff lock can be used in our Land Rover in both 4 Low and 4 High settings which can be helpful in higher speed loose road surface conditions. The simple answer is that unlocking your center diff is the reverse of the instructions to lock it. In reality sometimes your center diff won’t unlock once you perform the correct steps to unlock it.