How do you fix a broken license plate light?

How do you fix a broken license plate light?

1. Step 1: Remove the license plate light lens cover. Remove the hardware holding the license plate light lens cover in place.
2. Step 4: Install the replacement bulb. Place the new bulb into the bulb socket.
3. Step 1: Open the trunk.
4. Step 2: Pull back the trim carpet.
5. Step 3: Remove the license plate light bulb socket.

How do I change my LED license plate?

Part 1 of 2: Remove the bulb

1. Materials Needed.
2. Step 1: Locate the license plate light.
3. Step 2: Determine which bulb has failed.
4. Step 3: Remove the license plate light cover.
5. Step 4: Remove the bulb.
6. Materials Needed.
7. Step 1: Install the new bulb.
8. Step 2: Complete the installation.

How do you change the light bulb on a Toyota Camry?

Replacing the license plate bulb on a Vehicles is simple. Open the trunk to the Toyota Camry. Remove the interior trunk liner from the back of the vehicle. Use a Phillips screwdriver to twist the small center screw from the middle of the plastic fastener.

Where do I change the light on my license plate?

Replace the black plastic cover and press in on the clips to lock the panel in place. Close the trunk and turn on the lights to test the new bulb. Locate the license plate light assembly in the rear bumper, directly above the license plate.

How do you replace a 2825 license plate light bulb?

Grab the bulb under the lens and pull it from the assembly. Grab a new 2825 license plate bulb with a clean, lint-free cloth and press it into the license plate light assembly. Don’t touch the bulb with your bare hands, as the oil from your hands can cause premature bulb failure.

How do you change the light bulb on a car?

Remove the interior trunk liner from the back of the vehicle. Use a Phillips screwdriver to twist the small center screw from the middle of the plastic fastener. The screw will come up about 1/4 of an inch and then you can pry the entire fastener/plug from the predrilled hole.