What to do if your Toyota 4Runner ignition switch fails?

What to do if your Toyota 4Runner ignition switch fails?

If your Toyota 4Runner ignition switch begins to fail, replace it immediately with a part from AutoZone to prevent being stuck in your driveway. Your ignition switch is a key component in your ignition system, sending the key signal to the starter relay and the rest of the ignition system. If your ignition switch wears out, your truck won’t start.

What to do if your Toyota Dashboard Light goes off?

Have the vehicle inspected by your Toyota dealer immediately. Have the vehicle inspected by your Toyota dealer immediately. Immediately stop the vehicle in a safe place and contact your Toyota dealer. Immediately stop the vehicle in a safe place and contact your Toyota dealer. Indicates a malfunction in the vehicle’s charging system.

When does the indicator light stop flashing on a Toyota?

The indicator light stops flashing after the ENGINE START STOP switch has been turned to ACCESSORY or IGNITION ON mode to indicate that the system has been canceled. The indicator light flashes after the key has been removed from the engine switch to indicate that the system is operating.

What do the yellow and red symbols mean on a Toyota dashboard?

Yellow icons indicate an item of importance (such as low fuel), but are not necessarily a warning. Red icons indicate a condition that requires immediate attention, such as an open door or low engine oil pressure. See your vehicle’s Owner’s Manual for more details. Countless.

Where can I get a starter for my 4Runner?

I tried autozone…nothing but full starters and solinoid. you gotta get them from toyota dealership. i paid around 30-40 bucks for them. 2 small pieces of metal i remember. taking out the starter is the task tho. changing the pieces are not too hard.

Is there a problem with the 3rd gen ignition?

Also another common issue with the 3rd Gen also. There is what I’ll call a carrier for the ignition lock switch and tumbler. In that bracket it will sheer off part of it after time. We just did one in our shop this week.

What kind of engine does a Toyota 4Runner have?

Blue wire mod, 99 tall springs, 32″ Duratracs, Satoshi Grill, Tundra 231 brakes, 99 center console. 1988 3.0l 5spd Pickup SAS on 35s with 5.29’s, welded 8.4 rear, custom flat bed, on board air, XRC8 winch, homemade sliders. Its the contacts most likely. Mine is on the jack stands right now getting this fixed. Here is the thread I used: