How do you replace the rear differential on a Toyota Tacoma?
Remove the cotter pin. Pull the post. Remove the E-brake line, replace the post and cotter pin. Remove the four 10mm bolts on the back of each wheel hub. Remove the brake line from each wheel and watch for leaks, as you’ll lose some brake fluid. Figure 2. Remove the emergency brake lines. Figure 3.
What are rear axle bearings on a Tacoma?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: YwOMjzVnR7hD_A7H)
How do you replace the brake line on a Toyota Tacoma?
The emergency brake line connects to a spring loaded level attached by a cotter pin on a post. Remove the cotter pin. Pull the post. Remove the E-brake line, replace the post and cotter pin. Remove the four 10mm bolts on the back of each wheel hub. Remove the brake line from each wheel and watch for leaks, as you’ll lose some brake fluid.
How do you lift the rear end of a truck?
Use a hydraulic floor jack and lift the rear end of the truck. Use jack stands on each side, right under the axle on either side of the differential. Lower the truck onto the jack stands. Remove the rear tires. Figure 1. Jack up the rear end of the truck and place on jack stands. Always use jack stands when working underneath your truck.
How much does it cost to replace engine in Tacoma truck?
Option A: spend $7000 for a New engine in an otherwise solid truck and you have a new truck. Should be good for another 300k. Option B: buy a used Tacoma with whatever number of miles with whatever service history and you might only get 10k miles out of before you are in the same place. Seems clear to me.
How do you change oil in a Tacoma?
When filling, the oil will begin to run out at some point. Put the plug in the fill hole, and let the gear oil run down into the lenght of the axle shaft. After a few minutes, remove the plug and begin to fill again. Remember to replace your fill plug! And to torque the fill plug, and drain plug to 36 ft- lbs
How do you change gear oil in a differential?
Step two, remove the lower plug (“drain plug”). Be sure your jug/can/tub/pan is handy. While the old gear oil is draining, take the time to clean off the magnet on the end of the plug. When the oil has completely drained, replace the lower or “drain plug”. Now you can begin to refill your differential!