How long do distributor wires last?
The ignition cables on a car are made to last about 60,000 miles before they have to be replaced. In some cases, the wires will need to be replaced due to the rubber boots on the end getting damaged and now allowing for a good connection with the spark plugs.
How do you remove the wire from a distributor cap?
When removing wires from the spark plug or distributor cap, twist or rotate the boot to loosen it from the plug. Do not jerk or tug on the wires or you may break the connection. Be sure to only pull on the boot; do not pull on the cable itself.
What are the different colors of Toyota wires?
A Terminal (Female) Housing (Female) Housing (Male) Terminal (Male) Wire Harness (W/H) Electric Wire Terminal Housing Fuse Other J/B (Junction Block) R/B (Relay Block) Insulator Copper Wires (Conductor) B = Black W = White L = Blue BR = Brown V = Violet SB = Sky Blue R = Red G = Green P = Pink LG = Light Green Y = Yellow GR = Gray O = Orange
What do you need to know about Toyota connector repair?
A step–by–step section on connector repair and terminal repair is included. There is a section of charts with terminal and connector illustrations, part numbers, and notes on terminal removal. By using this guide, a satisfactory repair of the wiring harness and connectors in Toyota vehicles will be easy to achieve.
How big is a Toyota wire harness repair manual?
Wire Harness Repair Manual (RM1022E) A Tab width 0.64 mm A–1 INTRODUCTION–GENERAL INFORMATION 5 Wire Harness Repair Manual (RM1022E) GENERAL INFORMATION This manual provides instruction in the following repairs: How to Inspect for System Inspection Circuit Protection Terminal and Connector Repair Procedure
How to replace a distributor rotor and cap?
This will help you mark where the “pointed end” of the new rotor should be placed. Step 7: Remove the rotor screw and remove the rotor: On some distributors, the rotor will be secured to a small screw, typically in the middle of the rotor or along the edge. If your rotor has this screw, carefully remove the screw using a magnetized screw driver.