How do you remove a crank pulley bolt on a Tacoma?
First, use the flat blade screwdriver to remove 4 of the 5 plastic plugs that hold the rubber flap onto the frame on the inside of the passenger side fender well. Remove your skidplate if you have one. My truck is lifted 3″. You may need to get your truck off the ground a little if you’re at stock height.
What kind of bolts do you use to remove cylinder heads?
Cylinder heads come in many different configurations that each have their own specific steps to remove. There are two types of removal: head bolts from a pushrod style motor and the overhead cam style engine. Each one has differences but the tools used will be similar and the precautions the same.
How much torque does a Toyota Tacoma have?
How to Torque a Toyota 2.7 Head. The Toyota 2.7-liter engine produces 159 horsepower and 180 foot-pounds of torque. It’s the base engine of the Tacoma and the 4Runner. The cylinder head and engine block of the Toyota 2.7-liter engine are joined together by head bolts with a gasket sealing the joint.
How do you Torque a Toyota 2.7 head?
Coat the threads of the bolts with motor oil. Finger tighten the bolts. Use the torque wrench to tighten the bolts to 29 foot-pounds, starting with the inner bolts and working outwards. Tighten the bolts in the same sequence another 90 degrees. Do the same procedure again.
What’s the best way to turn a crank pulley?
Put the 22mm socket on your breaker bar. Use the 22mm socket to turn the crank pulley so that the 2 holes are lined up vertically. With your pulley holder tool set up, get under the truck and pass the handle end towards the opening on the passenger fenderwell.
What to do if your Toyota won’t start?
Battery – If the connections on your battery become corroded, there is no longer a connection to the rest of the car. This can keep you from starting. Clean the posts and try to start the car. Additionally, the battery may be dead. Take a battery tester and test the cranking amps to see if they are weak.
How do you remove a pulley from a crank pulley?
Lay the handle on top of the frame. Place the tool behind all the fluid lines except the one you removed the 10mm bolt to. The tool goes in front of this line. You can move the larger fluid line closest to the pulley out of the way since you removed the bolt.
Where to put pulley holder on Tacoma truck?
With your pulley holder tool set up, get under the truck and pass the handle end towards the opening on the passenger fenderwell. Lay the handle on top of the frame. Place the tool behind all the fluid lines except the one you removed the 10mm bolt to.
Are there any Toyota crankshaft tools left in stock?
Only 4 left in stock – order soon. . In stock on May 11, 2021. . Only 14 left in stock – order soon. . . Only 9 left in stock – order soon. . Only 1 left in stock – order soon. . . Only 11 left in stock – order soon. . Only 20 left in stock – order soon. . . Only 3 left in stock – order soon.