How do you replace a front shaft seal?
Method 1 of 1: Replace a front output shaft oil seal
- Materials Needed.
- Step 1: Jack up front of vehicle and set jack stands.
- Step 2: Place wheel chocks on the rear wheels.
- Step 3: Mark positions of driveshaft, flange, and yoke.
- Step 4: Remove bolts securing driveshaft to the output flange.
What is a transfer case output seal?
The output shaft seal is the part of the transfer case that connects the case to the axle. Its job is to prevent fluid from leaking out of the transmission and to keep fluid from leaking out of the front and rear output shafts to the differential. These seals can dry up, wear out and break.
What is a front output shaft seal?
The front output shaft seal is an oil seal that is installed on the front of transfer cases. As its name implies, the front output shaft seal is responsible for sealing the front output shaft of the transfer case, keeping the gear oil or transmission fluid inside of the unit.
Where is the oil seal on a transfer case?
Average rating from 5 customers who received a Transfer Case Output Shaft Seal Replacement. The front output shaft oil seal is located on the front of the transfer case on a four wheel drive vehicle. It seals the oil into the transfer case at the point where the output shaft meets with the yoke for the front driveshaft.
How to disassembly transfer a Toyota Land Cruiser?
SEPARATE FRONT CASE AND REAR CASE (a) Using a snap ring expander, remove the snap ring from the rear case. (b) Remove the 8 bolts. (c) Using a brass bar and hammer, tap the rear case and separate it. 15. REMOVE 2 BEARING RACES FROM REAR CASE 16. REMOVE INPUT SHAFT ASSEMBLY Using a plastic hammer, remove the input shaft assembly from the front case.
How to remove front transfer case output shaft?
How to remove front transfer case output shaft to replace seal hzj 80 series landcruiser How to remove front transfer case output shaft to replace seal hzj 80 series landcruiser – Answered by a verified Toyota Mechanic We use cookies to give you the best possible experience on our website.
How to replace input shaft oil seal in Toyota Land Cruiser?
IF NECESSARY, REPLACE INPUT SHAFT OIL SEAL (a) Using SST and a hammer, drive out the oil seal. (b) Apply MP grease to the lip of a new oil seal.