What kind of starter does a Toyota 4Runner use?
If you notice a single loud clunk or click when you turn the ignition key or slow engine turnover, check your 4Runner starter motor’s condition. Our engine starters are designed to utilize a 12-volt, high-amperage battery, guaranteeing to turn your engine and start you vehicle in no time.
What was the horsepower of the 1985 Toyota 4Runner?
This upped the horsepower numbers from 100 hp for the 22R, to 116 hp for the 22R-E Engine, though the carbureted engine remained available until 1988. Additionally, rear seats were available in all 1985 4Runner trim levels, not just the more upscale SR5.
When did the Toyota 4Runner 5th generation come out?
The fifth generation 4Runner was unveiled at the State Fair of Texas on September 24, 2009. It is available in 3 trim levels, 2 of which were available previously. The base SR5 trim as well as the top-of-the-line Limited trim are available as a 2WD or a 4WD.
What kind of transmission does a Toyota 4Runner have?
Trucks sold with the V6 engine were equipped with the same heavy duty rear differential that was used in the turbocharged trucks, as well as a completely new transmission and transfer case; the transfer case was chain driven, although considered less rugged, created less cab noise than the old gear-driven unit used behind the four-cylinder engine.
Can a bad ignition switch cause a Toyota 4Runner not to start?
A bad ignition switch can cause your 4Runner not to start at all. And, it can keep your 4Runner from starting in a couple of different ways. The first is when the starter cranks, but the bad ignition switch doesn’t turn on the fuel pump or ignition.
Where is the solenoid on a Toyota 4Runner?
If you hear a clicking noise and nothing else, check the wires connecting to the solenoid and starter to make sure they are solid, unbroken and firmly connected. The solenoid is a black or blue cylinder located on the side wall of the engine, near the battery, usually on the passenger side.
Is there a problem with my Toyota 4 Runner?
Toyota 4 Runners are known for their reliability under all sorts of conditions. This doesn’t mean that you won’t encounter problems with them on occasion, but knowing how to check for what is wrong can help you determine if the problem needs the attention of a professional mechanic, or if it is a small job you can do in your driveway.
Why is my Toyota 4Runner not turning over?
If you can’t get your 4Runner to turn over, or it cranks very slowly, it could be a bad starter. If the battery tests good, and all the wiring looks good, the next logical cause is the starter itself. It’s also a possibility that the starter could still be good, but it may just need a good cleaning.
Where is the starter located on a 2nd Gen truck?
Figure 3. Starter location through wheel well. (Note: This is a 2nd gen truck.) Remove the two 12mm bolts that secure the brake line to the frame, and move aside the brake line. Remove the plastic intake tube between the intake manifold and the air box, so you have better access to the starter from above.
How do you jack up a Toyota 4Runner?
Loosen the lugs on your passenger side wheel before you jack up your truck. Use a hydraulic floor jack to lift your truck and place on jack stands in the approved locations. Figure 1. 4Runner jacking and jack stand points. Figure 1. Always use the approved jacking points to lift your 4Runner. Always use jack stands when working under your truck.