How do you change the bearing on a Toyota Tundra?
Just take the C-clip and see if you can fit it in the groove on the axle. To get the old retainer off, pry it apart with a flat bladed screwdriver in the slot you cut into it with the cutoff wheel and slip it off. Next, put the new bearing retainer on the axle shaft, followed by the old retainer and pipe.
How to replace front wheel unit bearings in Toyota 4×4?
You have two options for doing the job: 1st is to buy pre-assembled unit bearings. These are new bearings, seal and 4 bolts with a new wheel hub spindle already pressed into the wheel bearings. This is a direct just swap out the unit bearing and cost about $100 more per side.
How do you remove the wheel hub spindle from a Toyota?
Using a shop press, press out the wheel hub spindle from the bearing. Make sure you use the appropriate size Toyota front wheel bearing tool (we are using a large socket) only pushing on the wheel hub spindle.
Why is my rear axle not working on my Toyota Tundra?
The clackity-clack noise was a big clue. It took me two full days of researching on the internet to get to the point to where I felt confident about pulling the axles, buying the correct parts, and at least taking the axles to a machine shop.
How do you take axle shaft out of Ford tundra?
A Ford 9″ comes apart in a similar way and when I disassembled my Ford 9″ for new bearings, I had to use a slide hammer to pull the shafts out. You were able to get your shafts out without one I take it? Do you have a pic of the axle and bearing assembly out of the housing?
How do you replace a rear axle bearing?
That old bearing retainer can be used to judge if the bearing is fully seated. Just take the C-clip and see if you can fit it in the groove on the axle. To get the old retainer off, pry it apart with a flat bladed screwdriver in the slot you cut into it with the cutoff wheel and slip it off.