What causes alternator belt to shred?
If you have an AC compressor or an alternator that is trying to lock up, the extra load on the belt will make it slip, and eventually burn up. Additionally,if any of the mounts are loose, causing alignment issues, then the belt will not last very long. As a final thought, make sure the routing of the belt is correct.
Can a loose belt cause rough idle?
Vehicle performance issues can also indicate a problem with your vehicle’s serpentine belt because bad serpentine belt causes loss of power. So if you have searched for answers to the question, can a bad serpentine belt cause rough idle? The answer is yes.
Can a drive belt be replaced on a Toyota Tacoma?
Fortunately, it is not too hard to replace that belt. This article applies to the Toyota Tacoma (1996-2015). Different types of vehicles make use of drive belts to run their accessories, such as the alternator or air compressor, on a engine.
How to change the alternator belt in a car?
Work in reverse, start with the alternator belt. Slip on the new belt, and torque the pivot locking bolt to spec (you can hand tight the locking bolt.) Adjust the tension of the belt. Step 9. Install the water pump/AC belt. Tighten the idle pulley locking nut and adjust the tension of the belt as needed. Step 10. Install the power steering belt.
How does the serpentine belt on a Toyota Tacoma work?
This pulley is mounted on a swivel that can be loosened by rotating it clockwise with a ratchet. When the tensioner is loosened, the belt gets enough slack to give your hands space to remove it.
Where is the tensioner on a Toyota Tacoma?
After lifting the belt off, gently allow the tensioner to move back to its location. The location of every tensioner varies according to the type of engine you have, but is generally found on the upper portion of the pulley assemblies. Figure 2. Shows the location of the tensioner pulley.