What size socket do I need to remove the oil pan?
3/8-inch
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine.
Why is my oil pan drain plug leaking?
There can be several reasons why your drain plug is leaking. Your plug may use a crush washer, a gasket or a combination of these two components to help seal it. It’s also possible that the plug was installed too tightly, causing the threads to be damaged and oil to leak out past them.
Are all oil pan drain plugs the same?
Are all oil pan drain plugs the same? All drain pans are not designed the same which is why different drain plugs are required for different vehicles. There is as much engineering going into the oil drain plug as any other part or system on the vehicle. Some vehicles have a reinforced drain plug hole and others do not.
Where can I find a replacement oil drain plug?
The Process Drain just about every drop of oil from the car. Jack the car up in the front, so it tilts away from where the oil pan drain is located. Clean the drain plug opening thoroughly with brake cleaner or acetone and let the car sit in that position until the oil pan drain opening is perfectly dry Mix the JB Weld.
What size wrench do I need for the oil pan plug?
The oil pan drain plug should require a 14mm hex head wrench to remove. The transmission pan requires a 10mm allen head socket, or wrench to remove. Are you sure you’re trying to remove the correct drain?
How do you loosen oil drain plug?
Drain and replace the oil filter. Crawl under, and find the engine oil screw near the front. Where you plug in the socket, use the wrench to loosen the plug in a counterclockwise direction. Once relaxed, you can use your hand and remove the plug. The hot oil will begin to pour out. Ensure that all the old oil goes into the pan.
Where is the drain plug for the engine oil?
The oil drain plug is typically located on the bottom of the engine on the oil pan. It is used to drain the oil from your pan during an oil change. If you notice a leak at the oil plug, in some cases it can be as simple as replacing the gasket. If the bolt or oil pan have been cross-threaded, you may need a new oil drain plug.