What is the part number for a Toyota Sienna power sliding door?
In my case the part number was PAN14EE12AA1 for Toyota Sienna 2006 XLE, I ordered it from DigitKey for $6.70 (after tax and shipping) for each door. After getting a new motor, insert the motor back. You may need a magnifying glass to view the flat side of the motor shaft.
What to do when your Sienna’s side door fails?
The only way you can get the door open is to pull the handle and then hold it for two or three seconds. This happens when the latch motor fails, which is fairly common in Toyota Siennas. Luckily, replacing just the latch motor is an easy and inexpensive solution. 2.
Why is my power sliding door not working?
Most common problem is the motor of the latch fails. Replace only the motor of the latch instead of the entire latch unit. There are many resources such as YouTube of how to open the inside cover panel so I will not go into detail here.
Why is my Toyota Voxy sliding door jammed?
It may be possible that the fuse for sliding doors has blown and needs to be replaced. If the fuses all check out, then it may be possible that the sliding door actuators themselves are the issue. These are located inside the door and would require disassembly of the door and panel to access.
Why is the sliding door on my Sienna XLE not working?
It would only work when I pulled the handle. Here is a breakdown of the symptoms I was having with my 2004 Toyota Sienna XLE: All of this is pointing to the motor inside the door that essentially “pulls the handle” for you when you remotely open the door.
How to replace side door cable on Sienna?
Without further ado, here’s how you can replace the side door cable assembly in your Sienna: Take out the seat closest to the defective sliding door. (Optional; this just gives you more room to work on the door.) Roll down the window on the defective door. On the side of the door is a hex screw holding the plastic panel in place. Remove the screw.
Where is the release actuator on a Sienna?
There’s a pulley system with a Sienna side door release actuator in the bottom corner of the door. (If you’re working on the right door, the pulley system is in the bottom right corner; on the left door, the pulley system is on the bottom left corner.) Remove all of the screws holding it in place. Slide-out the side door cable assembly.
How much does a 2001 Sienna Le cost?
My 2001 Sienna LE right side power door quit working and was going to cost about $1200 for a new drive motor and ECU. I decided to remove the drive motor and cable to convert it to a manual door. It slides just as easy as the manual left side door now. It wasn’t too difficult to do.
Where is the power switch on a Toyota Sienna?
The 2nd Generation power switch is located to the left of the steering wheel, on the lower portion of the dashboard near the driver’s left knee. You can conceivably turn the power “off” and use the door manually all of the time, or as needed.