How to replace the fuel filter on a Celica?

How to replace the fuel filter on a Celica?

How to Replace the Fuel Filter on a Celica Step 1. Remove the fuse for the fuel pump. The fuse compartment is located near the bottom of the dash next to the… Step 2. Start the car with the fuse removed and allow the engine to idle until it runs out of fuel and dies. Step 3. Remove the negative

Where is the fuse on a Toyota Celica?

Toyota cars build up a substantial amount of pressure in the fuel system, therefore proper steps and procedures should be followed when replacing the fuel filter in a Celica. Remove the fuse for the fuel pump. The fuse compartment is located near the bottom of the dash next to the cigarette lighter behind a pullout cover.

How do you get fuel out of a fuel filter?

Place a shop rag or old towel over the top of the fuel filter to eliminate any fuel spray that may be trapped under pressure. Loosen the banjo nut using a 17mm wrench slowly to allow fuel to bleed and drain out of system.

What to do if your fuel pump won’t start?

Use a circuit tester to check all the electrical connections to the fuel pump. Turn the key to ON. If you see a current, then it is not the pump. If there is no current, check the fuse.

Can a clogged fuel filter cause an engine to stall?

It’s true that sometimes when the filter is clogged or partly dirty, fuel will somehow go through the filter but will substantially clog the car’s injector or carburetor. And when this happens, it will cause the engine to stall, having start problems and much more.

How do you replace the fuel pump in a Toyota Camry?

Replace the “C/OPN” relay, reconnect the negative battery cable and fill the fuel tank if it is empty. Pressurize the Camry’s fuel system by turning the ignition on for a couple of seconds. Then turn it off for ten and repeat this five to ten times.

How do you remove a fuel pump from a car?

You can now withdraw the fuel pump from the housing. Connect the new fuel pump into place on the assembly housing. Reassemble the fuel pump/sending unit in order, from the electrical connector to the fuel sock filter, rubber isolator and bottom plastic support. Place the pump unit back within the fuel tank and reattach the bolts.