How do you replace the clutch on a Toyota Camry?
When replacing the clutch, it is best to purchase a clutch kit, which contains the clutch, disc, release bearing, alignment tool and spline lube. Disconnect the battery ground cable with a wrench. If your Camry has an airbag, wait 90 seconds before proceeding. Disconnect the battery’s positive cable. Remove the battery with the appropriate sockets.
How do you remove the starter from a Camry?
Raise the Camry with a floor jack and support it on jack stands. Remove the wiring from the starter. Put the nuts back onto the studs so you don’t lose them. Unbolt and remove the starter with the appropriate socket. Unplug the speed sensor connectors, park/neutral position switch connector and the direct clutch speed sensor.
How to disconnect throttle cable on Toyota Camry?
Disconnect the battery ground cable with a wrench. If your Camry has an airbag, wait 90 seconds before proceeding. Disconnect the battery’s positive cable. Remove the battery with the appropriate sockets. Unscrew then remove the air cleaner assembly with the appropriate sockets. Disconnect the throttle cable from the throttle body.
What do I need to replace the clutch in my car?
This includes replacing the pilot bearing which the transmission input shaft goes into, the throwout bearing which engages the pressure plate via the clutch fork, the flywheel which I upgraded to an aluminum light weight flywheel, and finally the rear main seal because that is a common wear item which causes oil leaks in higher mileage motors.
When to replace automatic transmission fluid in Toyota Camry?
When to Replace Your Automatic Transmission Fluid. The Toyota Maintenance Guide for the four-cylinder Camry 5SFE engine says to inspect the automatic transmission fluid (ATF) every 30,000 miles. It doesn’t say when or whether to replace the fluid, but in general, mechanics recommend a simple “drain-and-fill” every 30,000 miles.
What causes a transmission leak in a Toyota Camry?
If so, the axle will have to be pulled from the transmission, the seal pried out from the transmission, a new seal pressed in, and the axle shaft reinstalled. A leak from the valve cover plug (on the right side of the engine) is likely a leak of engine oil, not a transmission leak.
How do you flush a Toyota Camry transmission?
The engine’s hydraulic pressure pumps new ATF through the system to push out an additional 4 quarts of trapped ATF. Before doing a flush, perform a drain-and-fill and drive the car for a few days. The new fluid’s detergent additives will dissolve harmful deposits from transmission components.