How to replace accessory belt on Toyota Corolla?
Place the new belt down on to the left (passenger) side of the engine and wrap the ribbed side around the lowest large pulley near the rear of the engine. Then bring it upwards and wrap the smooth side over the tensioner pulley and continue to the upper pulley at the rear of the engine and wrap the ribbed side over it.
What kind of serpentine belt does a Toyota Corolla use?
A few compatible new serpentine accessory belts for a 2003-2008 Toyota Corolla equipped with A/C (air conditioning) with their part numbers are as follows: Continental Elite 4060740 , Bando 6PK1880, Toyota 90080-91139-83, Drive-Rite V-Ribbed Belt # 740K6, Dayco Poly-Rib Belt # 5060740 and also the Gates K060739.
When to replace timing belt on Toyota Corolla?
Avalons with a V6 made from 2005 on are equipped with a timing chain, so you there’s no recommended service needed. Corolla. Owners of 4-cylinder Corollas from 1990 to 1997 will have a timing belt that needs to be replaced every 60k miles to avoid potential damage from a broken belt.
How to replace drive belt or serpentine belt?
How to replace drive belt or serpentine belt Toyota Corolla. VVT-i engine. Years 2000-2009. – YouTube
What kind of engine does a Toyota Corolla have?
Owners of other vehicles equipped with the 1.8L 1ZZ-FE engine such as the Toyota Celica, Allion, Premio, Vista, WiLL, Caldina, Matrix, Avensis, Opa, Isis, RAV4, Wish, Chevrolet Prizm, Pontiac Vibe, and Lotus Elise may also find these instructions to be helpful.
How do you replace the serpentine belt on a Toyota?
An adjustment bolt on the alternator provides belt tension on Toyota’s 1.8L engine. This belt is easier to replace than many, but does require that the alternator mounts are loosened up.
How do you remove a pulley belt from a car?
With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well. Compare the new belt to the old one.
This engine was used from 2009 to 2013 and is also found on the Yaris, Matrix, Scion xD and Pontiac Vibe. Shown is a 2010 Toyota Corolla. Tools: 10, 12 and 14mm 3/8″ sockets and ratchet, breaker bar (optional).