Do you grease rear end bearings?
If you have a sealed unit bearing, you wont need to pack or grease them. “The rear whel bearings recieve their lubrication from the rear axle. When installing bearings which have been cleaned, prelube with wheel bearing grease.” New bearings are clean too.
Can I mix grease with gear oil?
For example, gear oil may include a sulfur-phosphorus extreme-pressure (EP) additive. This is suitable for nearly every type of gear with the exception of a worm gear configuration. Therefore, mixing oil and grease will change the ratio of the base oil to the thickener, resulting in a lower consistency grade.
What’s the best way to replace a wheel bearing?
Step 5: Install the new bearing. Place the new bearing into the back of the rotor and apply grease to the inside bearing cavity. Install a new bearing seal over the new larger bearing and slide the rotor back on to the spindle. Tip: A rubber mallet can be used to tap the bearing seal into place.
Where are wheel bearings located on a truck?
If the wheel bearings are housed inside your disc brake rotor, as often seen in trucks, you will need to pry off the central dust cap to expose the cotter pin and retaining nut. To do this, use your pliers to remove the cotter pin and retaining nut and then slide the rotor forward to release the outer wheel bearing (smaller wheel bearing).
How do you replace rear wheel bearing on IRS itinerant?
Tap out the stub axle with the ball peen hammer and a block of wood against the end of the axle/nut. If it refuses to budge, re-install the axle nut AGAIN and make it flush with the end of the axle so you do not distort the axle or mash the axle nut threads. This axle steel is not especially hard, be mindful. Now hit with authority and precision.
Where do I find bearings and seals for my car?
If you are replacing the bearing, the new part number must match the old one. To select part numbers for either bearings or seals, consult the SKF Passenger Car, Light and Medium Truck Seals and Bearings Catalog (SKF #457205). 2.