How to read a check engine light code?

How to read a check engine light code?

How to Read Codes From Your Check Engine Light (For Older Cars) Step 1: Find Your Vehicle’s Diagnostic Plug . The first step is to find your vehicles diagnostic plug. The one in my car was a small blue plug that was Step 2: Bridge the Wires. Step 3: Watch the Flashing Light and Decipher the Code.

How to ckeck engine light codes?

Chevy Check Engine Light Codes Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. Turn the ignition on. Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).

What are check engine light codes?

A flashing check engine light means pull over and tow the vehicle to prevent damage. The P0400 codes relate to the emissions system and fuel vapor leaks (Gas Cap Codes). These in my opinion remain common and can experience intermittent failures.

How do you check engine codes?

With the wire in place, put the key in the ignition and put the car into the “run” position. That’s two clicks for Honda users. Wait a second and keep your eye on the check engine light. You should see it start to light up in a series of flashes. The light is blinking in a simple code of long and short.

How do you check the Check Engine light?

Put your key in the ignition and switch the vehicle to “on.” Do not start the vehicle. Once the lights on the dash come on, turn off all the vehicle’s accessories, like the radio. Then, press the “read” button on the scanner to access the check engine light code.

Can there be codes without check engine light on?

There are other cases where there’s no check engine light but codes. For example, any problem that affects the emissions system will automatically light the check engine light. But if the problem is not emissions related, and also not critical, it may be stored in the computer but not light the check engine light.