How do you change transmission fluid on a Toyota Tacoma?
The overflow plug works as your dipstick, so fill the transmission with fluid until oil starts overflowing from that plug. Read on to learn how to replace the transmission fluid on your Toyota Tacoma.
How do you replace the overflow plug on a Toyota Tacoma?
The overflow plug works as your dipstick, so fill the transmission with fluid until oil starts overflowing from that plug. Read on to learn how to replace the transmission fluid on your Toyota Tacoma. Locate both the fill plug and the overflow plug, then remove them.
Where is the refill plug on a Toyota Tacoma?
You can find the refill plug by following the driveshaft, you will find it on the side of the transmission. On the bottom of the transmission pan, you will find two bolts; the one on the flat part of the pan is the drain plug, while the one that is in a groove, higher than the other plug, is the overflow plug. Remove the overflow plug. Figure 1.
Where is the fill plug on a Toyota truck?
Since most of us have no access to the Toyota tool, we must utilize method “B” and use the trucks onboard diagnostic system (OBD). 4-5 quarts of Toyota ATF WS (WS certification is the only compatible fluid). Remove the fill plug (24mm) which is located on the passenger side of the automatic transmission (AT).
What happens if you change the transmission on a Toyota Tacoma?
If replacement is necessary, contact your Toyota dealer. Using automatic transmission fluid other than “Toyota Genuine ATF Type T-IV” may cause deterioration in shift quality, locking up of your transmission accompanied by vibration, and ultimately damage the automatic transmission of your vehicle.
Can you use Genuine ATF WS on a Toyota Tacoma?
Using automatic transmission fluid other than “Toyota Genuine ATF WS” may cause deterioration in shift quality, locking up of your transmission accompanied by vibration, and ultimately damage the automatic transmission of your vehicle. *1: Minimum pedal clearance when depressed with a force of 110 lbf (490 N, 50 kgf) with the engine running.
How to drain / refill automatic transmission [ Tacoma World ]?
Then shifting from “P” to “N” (pausing briefly in “N”), began a series (six shifts) of “N” to “D” to “N” cycles with the shifter. After the 6 shifts are completed the red AT TEMP light should illuminate for 2 seconds (important to note).
Can you drain and fill your transmission fluid?
Welcome to Tacoma World….hope this video answers some and maybe all your questions about a drain and fill on your transmission fluid. Given the about of miles on the truck you might want to consider a pan drop and clean and reistall with new gasket after cleaning the pan and magnets.
How often should I change my transmission fluid?
This article applies to the Toyota Tacoma (1996-2015). Although the Toyota Tacoma doesn’t require changing the transmission fluid as often as your engine oil, it’s recommended you replace it more often once your truck goes over 100,000 miles.
Where are the transmission lines on a Tacoma?
There are 4 bolts (12mm socket) securing it. This makes access for the next step substantially easier and will save you time. Step 5: Locate the two ATF cooler lines on the passenger side of the transmission. You will see two lines close together running towards the front of the truck.
When to drain and refill a Toyota Tacoma?
Remember, the Toyota Service Manual describes the fluid being at the correct level when a “small trickle” escapes from the overflow hole. If a steady flow is found, it must be left to drain until all that remains is a “small trickle”.
When to change the transmission fluid on a Toyota PreRunner?
Transmission Fluid and Filter Change for a 2010 Toyota Tacoma PreRunner SR5 TRD Sport with a 5 speed automatic Transmission. Toyota recommends checking the Transmission fluid every 30,000 miles or so in extreme driving conditions; however, they don’t have a set maintenance schedule to service the transmission or change the fluid & filter.
What should fluid temperature be in Toyota Tacoma?
The fluid temperature MUST BE between 46°C (115°F) and 56°C (130°F) to accurately check the fluid level. Toyota techs utilize the Toyota computerized scan tool to accurately verify the ATF temperature. Since most of us have no access to the Toyota tool, we must utilize method “B” and use the trucks onboard diagnostic system (OBD).
How much fluid does a Toyota Tacoma have?
Tires/spacers 98 Toyota Tacoma Prerunner Turn Signal Automatic transmission fluid capacity? Discussion in ‘ 1st Gen. Tacomas (1995-2004) ‘ started by sirsaechao, Jul 14, 2012 .