How much is a water pump for a 97 Ford Ranger?
The average cost for a Ford Ranger water pump replacement is between $268 and $311. Labor costs are estimated between $162 and $204 while parts are priced at $107.
Can you drive without a water pump?
It is possible to drive your vehicle without a water pump, but not good to. Some people in the racing circuit or who drive racing vehicles purposefully remove their water pumps to obtain more horsepower to their engine. If you are driving a vehicle for everyday use though, a water pump is a must.
How much is a water pump for a 1995 Ford Ranger?
Compare with similar items
| This item SCITOO AW4095 Water Pump for 95-08 Ford Ranger Mazda B3000 3.0L V6 OHV 12v Water Pump W/Gasket | ACDelco Professional 252-470 Water Pump Kit | |
|---|---|---|
| Price | $3799 | $4819 |
| Shipping | FREE Shipping. Details | FREE Shipping. Details |
| Sold By | Scitoo Auto | Amazon.com |
Is it OK to drive with a leaking water pump?
You should be fine driving with the leaking water pump for a little while, but you should add coolant before very trip. Carry at least 5 gallons of distilled water with you since you never know if you need to go on a long trip.
Can I drive without a water pump?
How do you change a water pump motor?
Align the water pump face plate and hand-thread the four retaining bolts to get them started. Tighten them with the socket set. Lift the lower unit and replace it to the bottom of the motor. Hold it in place while you hand start the retaining bolts. Tighten them with your socket set.
How do you install a new water pump?
Install it to the new pump and slide the new pump back over the drive shaft into position. Align the water pump face plate and hand-thread the four retaining bolts to get them started. Tighten them with the socket set. Lift the lower unit and replace it to the bottom of the motor. Hold it in place while you hand start the retaining bolts.
How to change the water pump on a 1997 force outboard?
The water pump in your Force outboard takes on a lot of wear and tear, and as such, requires regularly replacement. The water pump draws in water and circulates it through the engine to keep it cool. Loosen the fasteners that hold the lower unit of your motor to the upper unit. Grab the lower unit and set it down where you will be working on it.
How to change the water pump on a 1997 120hp force?
Loosen the fasteners that hold the lower unit of your motor to the upper unit. Grab the lower unit and set it down where you will be working on it. Remove the water pump’s four retaining bolts and slide the pump housing down and off the drive shaft. Loosen the nut attaching the water tube to the old water pump and remove it.