How much does it cost to get an axle installed?
The Best in Auto Repair The average cost for axle shaft replacement is between $916 and $957. Labor costs are estimated between $155 and $195 while parts are priced at $762. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
How long does it take to install a axle?
It would take approximately 30 minutes to replace one axle. If a person actually wanted to repair an axle, if completely broken, then it would have to be welded. Welding an axle will not work, it weakens the steel to much to make it usable again. Front axles on most newer vehicles are a whole new game.
How many axles does a Toyota Corolla have?
Most cars or standard cars have four axles or two sets of axles, which helps in rotating the wheel.
Are axles expensive?
Your axles are some of the most basic parts in your entire car. You can strip down a vehicle to the bare bones of having some wheels and an engine, but the axles have to be there as well. On average, the cost of getting an axle shaft replaced on a vehicle is somewhere between $500 and $950.
Where are the CV axles on a Toyota Corolla?
The CV (constant velocity) axle shafts on a Toyota Corolla integrate the transaxle of the front wheel drive transmission with the wheel. There are two joint bearings on each end of the CV axle, protectively covered by a rubber boot to keep the joint bearings lubricated,…
How do you remove an axle from a Toyota Corolla?
Remove the hub nut on later model Corollas with the impact gun and a 30 millimeter socket. Lift the Corolla up high enough on the lift to determine if there are inner flange bolts holding the axle to the transaxle housing. The bolts are present in older models of the Corolla. Remove the bolts, if applicable.
How do you remove the hub nut from a corolla?
Place the Corolla on a lift, up to about waist level. Remove the hub cap. Remove the lug nuts with the impact gun and a socket. Remove the wheel. Remove the cotter pin, spindle cap and lock nut on older model Corollas. Remove the hub nut on later model Corollas with the impact gun and a 30 millimeter socket.