What kind of compression does a Toyota Corolla have?
I have a 2009 Toyota Corolla with 138,000. Check engine light shows a misfire cylinder 4. Mechanic today said cylinders 3 and 4 showing low compression. The only thing I noticed is car wants to idle a little rough when in park or stopping suddenly.
How to test engine compression on a corolla Prizm?
Testing the engine compression on your 4 cylinder Corolla (Prizm) is a pretty easy affair due to the fact that the spark plugs are easily accessible (since they have to be removed for the test). In this tutorial, I’ll show you how to troubleshoot a low engine compression problem causing a rough idle or a no start condition.
What does 0 psi mean on Toyota Corolla?
CASE 1: 0 PSI on all 4 cylinders. This is bad and it tells your that you have one of the following problems: Timing belt problem. Blown head gasket. Blown engine. Any compression value below 100 PSI (even if it does not 0 PSI) means internal mechanical engine trouble.
Is there a miracle in a can for a Toyota Corolla?
Restore is pretty good, there are other brands of miracle in a can that others like. You can buy a few more miles and quiet a noisy engine but not cure anything. None of these will fix a misfire. The coils sit right on top of the plugs and are easy to replace. If you have not replaced the plugs, now is a good time to do it.
How to repair valve clearance on a Toyota Corolla?
Toyota Corolla Repair Manual/ Emission control/ Valve clearance Adjustment 1. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 2. Disconnect engine wire Remove the 5 clamps from the 5 clamp brackets. Disconnect the 4 ignition coil connectors. Remove the bolt and nut installing the engine wire. 3.
What kind of engine do you need for a Toyota Corolla?
Recommendation: Start looking for a compatible used engine from a rear-end wrecked 2009 Corolla. You have one huge plus going for you, your choice of vehicle: Corollas are probably the biggest selling car in the USA, so there should be a lot of used engines available.
How to change the cylinder head on a Toyota Corolla?
Turn the crankshaft pulley, and align its groove with timing mark ”0” of the timing chain cover. check that the point marks of the camshaft timing sprocket and vvt timing sprocket are in straight line on the timing chain cover surface as shown in the illustration. : if not, turn the crankshaft 1 revolution (360 ) and align the marks as above.