How to replace front shock and strut on Toyota Avalon?
Front Shock and Strut Replacement. First, find a level piece of ground to park the Avalon on. Then, engage the parking brake. Next, remove the front tires and jack the front end into the air with support from jack stands. The front assemblies for the Avalon are under the front of the car.
How much does it cost to replace shocks and struts?
Although you can have individual struts replaces, typically you will find that both struts are replaced at the same time. To replace an individual strut, you are looking to pay anywhere from $133 and $439. To replace both the cost will usually be between $239 and $818.
What is done during a strut replacement in a car?
What Is Done During a Strut Replacement? The shocks and struts in your car are part of the suspension, and they help protect your engine and the rest of your vehicle from the various bumps in the road. Although you can have individual struts replaces, typically you will find that both struts are replaced at the same time.
How much does it cost to repair a Toyota Avalon?
Labor costs are estimated between $226 and $285 while parts are priced at $378. This range does not include taxes and fees, and does not factor in your specific model year or unique location. Related repairs may also be needed.
Where are the front assemblies on a Toyota Avalon?
The front assemblies for the Avalon are under the front of the car. You can locate them by looking for springs with hardware that runs through the assembly and connects to the end of the suspension. Find the wheel hubs and the brake hose that is connected to the strut. Disconnect the anti-lock brake sense and mounting bracket.
Where does the strut mount go on a Toyota?
The MacPherson strut front suspension consists of a coil-over strut type support that bolts directly to the steering knuckle. It turns as an assembly when the front wheels turn, pivoting on the lower ball joint at the bottom, and the upper strut mount at the top.
What should I do to my Toyota Avalon?
Disconnect the negative battery cable and rear seat cushions. You will also need to raise the rear of the Avalon with support from jack stands. Also, remove the rear wheels. Next, disconnect brackets and sensors from the strut and stabilizer bar link nut.
What’s the difference between a Toyota Avalon and a big two?
One huge difference between the Avalon and the big two was in the drive, the Avalon driving through the front wheels instead of the rear as local tradition dictates.
Where are the suspension arms located on a Toyota Avalon?
In looking at the Rear Suspension Components, the suspension arm #1 and #2 attach to the frame at the suspensio member and at the wheel at the rear axle carrier. It is the ones to the suspension member ( the ones in the middle of the chassis) that I am replacing in the rear, not the ones near the rear axle carrier and strut. Correct????
Are there sway bars on a Toyota Avalon?
The PU busings for the sway bars, both front and rear took longer than I wanted. The install for the rear were easy, as access to them was easy. Since the parts are really for a 97-99 Avalon, (there is no listed part for 2000-present), they are tight around the sway bar but not problems.
How to replace Shock and strut on Toyota Camry?
Make sure to torque the center nut to 36-foot lb. It is time to re-install the strut and you will start to do this by putting the strut to the frame. Install the upper mounting nuts and torque them to 29-foot lbs. Next, hand tighten the strut to the arm. Connect the link nut to the strut and replace any brackets or sensors.